AP Physics C: E&M · Unit 11 · 15-25% of the exam · about 85 minutes
Unit 11: Electric Circuits
By the end: Use current, resistance and power to analyze any DC circuit with series and parallel parts, real batteries and meters, solve multi-loop circuits with Kirchhoff's rules, and derive and read the exponential behavior of RC circuits.

- 11.1 Electric current and current density · 8 min
Current: charge on the move
- $I = \frac{dq}{dt}$ and $q = \int I\,dt$: charge is the area under an I-t graph.
- Current points the way positive charge moves. Electrons in a metal drift the other way.
- $J = I/A$ when uniform, $I = \int \vec J \cdot d\vec A$ in general, and $J = nqv_d$.
- 11.2 Simple circuits · 7 min
Closed loops, emf and schematics
- Current flows only in a closed loop. Open the loop anywhere and it stops everywhere in that loop.
- Emf ε is the work a source does per coulomb. An ideal battery supplies a fixed voltage, not a fixed current.
- Series: same current, no junction between. Parallel: same two junctions, same voltage.
- 11.3 Resistance, resistivity and Ohm's law · 9 min
What sets a resistance
- $R = \frac{\Delta V}{I}$. For a uniform wire, $R = \frac{\rho L}{A}$; ρ is a property of the material.
- Ohmic: R constant, straight I-ΔV line through the origin. In the material, $\vec E = \rho\vec J$.
- Non-uniform wire: series slices, $R = \int \frac{\rho\,dx}{A}$.
- 11.4 Electric power · 7 min
Where the energy goes
- $P = I\Delta V$ for any element. For a resistor, also $I^2R$ and $\frac{(\Delta V)^2}{R}$.
- Series: bigger R, more power. Parallel: smaller R, more power. Brightness follows power.
- Power delivered by the sources = power used by the resistors. Use it as a check.
- 11.5 Compound DC circuits: series and parallel · 9 min
Collapse, then expand
- Series: same current, resistances add. Parallel: same voltage, reciprocals add, result below the smallest.
- Collapse from the inside out to $R_{eq}$, find the battery current, then expand back out.
- Check with the junction rule (currents add up) and the power balance.
- 11.5 Internal resistance and meters · 8 min
Real batteries, real meters
- Real battery: emf ε in series with internal r. $\Delta V_{terminal} = \varepsilon - Ir$; $I = \frac{\varepsilon}{R + r}$.
- Terminal voltage equals ε only when no current flows. A short draws $\varepsilon/r$.
- Ammeter: in series, ideal R = 0. Voltmeter: in parallel, ideal R = infinite.
- 11.6 Kirchhoff's loop rule · 8 min
Walking around a loop
- Loop rule: $\sum \Delta V = 0$ around any closed loop. It's energy conservation per coulomb.
- Resistor with the current: $-IR$; against: $+IR$. Battery − to +: $+\varepsilon$; + to −: $-\varepsilon$.
- A battery driven backward by a bigger one absorbs power: it is being charged.
- 11.7 Kirchhoff's junction rule · 9 min
Junctions and multi-loop circuits
- Junction rule: $\sum I_{in} = \sum I_{out}$. It's conservation of charge.
- One current per branch; j − 1 junction equations; enough loops for the rest.
- A negative current is the right size, flowing the other way.
- 11.8 Resistor-capacitor (RC) circuits: charging · 10 min
Circuits that change with time
- Charging: $q = C\varepsilon(1 - e^{-t/RC})$, $I = \frac{\varepsilon}{R}e^{-t/RC}$, $\tau = RC$.
- A capacitor's voltage cannot jump. Empty, just after a switch: a wire. Long after: a break.
- After τ: 63% charged, current at 37%. After 5τ: within 1%.
- 11.8 RC circuits: discharging, networks and data · 10 min
Discharging, bigger circuits, and measuring τ
- Discharging: $q = q_0e^{-t/RC}$, with $I = -\frac{dq}{dt}$. Charge halves every $0.69RC$; energy halves every $0.35RC$.
- Networks: just after, empty capacitors are wires; long after, they are breaks with the voltage of their parallel partner.
- τ uses the resistance the capacitor sees, with batteries replaced by wires. Discharge paths can differ.
- Unit 11 wrap-up · 7 min
Put it together