11.2 Simple circuitsClosed loops, emf and schematics

Charge flows only around a closed loop. Break the loop anywhere, with an open switch or a cut wire, and the current stops everywhere in that loop at once. Charge doesn't pile up somewhere and wait, because a wire can't store charge the way a capacitor can.
The push comes from a source of emf, usually a battery. Its emf, written ε, is the work it does on each coulomb it carries from its − terminal to its + terminal: $\varepsilon = \frac{W}{q}$, measured in volts (joules per coulomb). The name comes from "electromotive force", but it's not a force. Think of the battery as a pump that lifts each coulomb up ε volts. An ideal battery keeps exactly ε between its terminals whatever you connect. The current that flows depends on the rest of the circuit.
?Wait, what's a volt again?
Two facts about wires make schematics readable. An ideal wire has zero resistance, so every point along one connected stretch of wire is at the same potential. And the shape of a drawing means nothing: you can stretch, bend and redraw wires any way you like, as long as you keep the same connections.
Series, parallel, or neither
Two elements are in series when all the charge that goes through one must go through the other, with no junction between them where it could split off. Series elements carry the same current. Two elements are in parallel when each of their two ends connects directly to the same two junctions. Parallel elements have the same potential difference across them. Many circuits mix the two, and some are neither: for those you'll use Kirchhoff's rules in Topics 11.6 and 11.7.
?Wait, what's a junction?
I thought about it. Show me
- (a) No. Between $R_1$ and $R_2$ sits the top junction dot, where the current splits between $R_2$ and the $R_3$-$R_4$ branch. Not all of $R_1$'s charge goes through $R_2$.
Why?
The test for series is "no junction between them". One dot is enough to break it. - (b) $R_1$. It sits in the only path between the battery's + terminal and the junction, so all of the battery's current passes through it.
- (c) $R_2$ and the $R_3$-$R_4$ pair as a whole. Both connect the same two junctions, so they share one potential difference. ($R_3$ alone does not have the same voltage as $R_2$: it gets only part of that branch's voltage.)
Why?
Name the two junctions in your justification. "Both are connected between the top and bottom junctions" earns the reasoning point.
Answer: (a) No, a junction separates them. (b) $R_1$. (c) $R_2$ and the series pair $R_3 + R_4$.
Stuck? Get a hint
- Find the junction dots first. They split the circuit into branches.
- Series: one branch, no junction between. Parallel: same two junctions at both ends.
- R₃ and R₄ share one branch, so they are in series with each other. That branch spans the same two dots as R₂.
- A3.0 J
- B27 J
- C0.33 J
- D12 J
Show the answer
B. $W = q\varepsilon = (3.0)(9.0) = 27$ J. Emf is work per charge, so multiply. The trap is 3.0 J, which divides 9.0 by 3.0 as if emf were charge per energy.
- Current flows only in a closed loop. Open the loop anywhere and it stops everywhere in that loop.
- Emf ε is the work a source does per coulomb. An ideal battery supplies a fixed voltage, not a fixed current.
- Series: same current, no junction between. Parallel: same two junctions, same voltage.
- A wire across an element shorts it: zero potential difference, zero current through it.