AP Physics C: E&M · Unit 11 lecture · Part 11 of 11 · 7 min

Unit 11 wrap-upPut it together

Mr. Thompkins
That's the whole unit. Let's zoom out. Two conservation laws ran through every section: charge (the junction rule, same current in series) and energy (the loop rule, power balance). Ohm's law ties them together at each resistor, and the capacitor adds one rule: its voltage can't jump.
IdeaEquationWhat it conserves or sets
Current$I = \frac{dq}{dt}$, $J = nqv_d$Charge flowing per second
Resistance$R = \frac{\rho L}{A}$, $\Delta V = IR$Material and shape
Power$P = I\Delta V$Energy per second
Junction rule$\sum I_{in} = \sum I_{out}$Charge
Loop rule$\sum \Delta V = 0$Energy per charge
RC circuit$\tau = RC$How fast a capacitor fills or empties
Unit 11 on one page.
?Wait, which rule is which conservation law?
The junction rule is conservation of charge: no charge piles up at a junction. The loop rule is conservation of energy: a charge that goes around a loop returns to the same potential. An easy way to remember: junctions count charges, loops count volts.
?Wait, what's the difference between ε and ΔV?
ε is the emf, the work a source does per coulomb, fixed by the battery's chemistry. ΔV is the potential difference between two points, which for a real battery's terminals is $\varepsilon - Ir$. For an ideal battery the two are equal.
Pause and think
Connect two topics: a capacitor in series with a bulb is connected to a battery. Describe what the bulb does over time, and why, using power.
I thought about it. Show me
It flashes bright and then fades out. Just after the switch closes the empty capacitor acts like a wire, so the current is ε/R and the power $I^2R$ is at its largest. As the capacitor charges, the current decays as $e^{-t/RC}$, so the power decays as $e^{-2t/RC}$, and the bulb dims to dark.

Traps that cost points

✕ Saying current is used up by a resistor, so the bulb nearer the battery is brighter.
✓ Series elements carry the same current. Energy is what gets used.
✕ Adding parallel resistors directly.
✓ Reciprocals add. The result is less than the smallest branch.
✕ Using the full battery voltage across one of several series resistors.
✓ Find the current first, then ΔV = IR for that resistor.
✕ Reading a real battery's emf off a voltmeter while current flows.
✓ It reads ε − Ir. Only with no current is it ε.
✕ Switching sign rules halfway around a loop.
✓ With the current through a resistor: −IR. Battery − to +: +ε. Every time.
✕ Saying a capacitor is full after one time constant.
✓ It is at 63%. About 5RC to get within 1%.
✕ Letting a capacitor's voltage jump when a switch moves.
✓ Find $V_C$ just before; it is the same just after.
✕ Using the wrong R in τ = RC.
✓ Use the resistance the capacitor charges or discharges through, with batteries replaced by wires.
✕ Putting a voltmeter in series or an ammeter in parallel.
✓ Ammeter in the loop, voltmeter across the element.

Key relationships for Unit 11

$I = \frac{dq}{dt},\quad q = \int I\,dt$
CurrentCharge is the area under an I-t graph
$J = \frac{I}{A} = nqv_d,\quad I = \int \vec J \cdot d\vec A$
Current density and driftNonuniform J: rings of area 2πr dr
$R = \frac{\rho L}{A},\quad R = \int\frac{\rho\,dx}{A}$
ResistanceUniform wire, or slices in series
$\Delta V = IR,\quad \vec E = \rho\vec J$
Ohm's lawOhmic materials
$P = I\Delta V = I^2R = \frac{(\Delta V)^2}{R}$
PowerBrightness follows power
$R_s = \sum R_i,\quad \frac{1}{R_p} = \sum\frac{1}{R_i}$
CombinationsCollapse, then expand
$\Delta V_{terminal} = \varepsilon - Ir$
Real batteryEquals ε only with no current
$q = C\varepsilon(1 - e^{-t/RC}),\quad q = q_0e^{-t/RC}$
RC charging and dischargingτ = RC; 63% and 37% at t = τ
$C_p = \sum C_i,\quad \frac{1}{C_s} = \sum\frac{1}{C_i}$
Capacitor combinationsOpposite of resistors

FRQ strategy for Unit 11

  1. Mathematical Routines: start from the loop rule in symbols, substitute I = dq/dt (or −dq/dt for a discharge), separate, integrate with the starting condition as the lower limit, and check both limits.
  2. Translation Between Representations: sketch $V_C$ and I against t with the right starting values, an asymptote drawn dashed, and the 63% or 37% point marked at t = RC. Draw circuits with correct symbols and meters in the right places.
  3. Qualitative/Quantitative Translation: reason in a chain (total R, battery current, local voltage, local current or power), name the rule at each link, and make sure your equations agree with your words.
  4. Experimental Design and Analysis: linearize (ln V against t, or ΔV against I), take the slope from the best-fit line, and say what the slope and intercept mean physically.
  5. Always show the equation in symbols before the numbers, and give units on every answer.
Mixed FRQ practice
A 12 V ideal battery, a switch, a 4.0 kΩ resistor and an empty 50 μF capacitor are in series. A 4.0 kΩ resistor is also connected directly across the capacitor. (a) Find the battery current just after the switch closes and long after. (b) Find the final charge on the capacitor. (c) Find the time constant. (d) In words, explain why the battery current falls.
  1. (a) Just after: the empty capacitor is a wire, shorting the second resistor: $I = \frac{12}{4.0\ \text{k}\Omega} = 3.0$ mA. Long after: the capacitor is a break, so the two resistors are in series: $I = \frac{12}{8.0\ \text{k}\Omega} = 1.5$ mA.
  2. (b) The capacitor shares the voltage of the resistor across it: $(1.5\ \text{mA})(4.0\ \text{k}\Omega) = 6.0$ V, so $Q = (50\ \mu\text{F})(6.0\ \text{V}) = 300\ \mu$C.
  3. (c) Seen from the capacitor, with the battery as a wire, the two 4.0 kΩ resistors are in parallel: 2.0 kΩ. $\tau = (2.0 \times 10^3)(50 \times 10^{-6}) = 0.10$ s.
  4. (d) As charge builds on the capacitor its voltage rises, so the current into it falls. Less of the current is diverted through the capacitor branch, the resistor across it takes more, and the total resistance the battery sees rises from 4.0 kΩ toward 8.0 kΩ, so the battery current falls from 3.0 mA toward 1.5 mA.
    Why?
    The claim (the current decreases), the cause (the capacitor's rising voltage), and the link to the battery (the effective resistance rises). Three links, three sentences.

Answer: (a) 3.0 mA, then 1.5 mA (b) 300 μC at 6.0 V (c) 0.10 s (d) the capacitor's rising voltage chokes off the current into it, so the battery ends up driving the two resistors in series.

Stuck? Get a hint
  1. Just after: wire. Long after: break. Redraw the circuit both ways.
  2. Long after, the capacitor has the same voltage as the resistor it's in parallel with.
  3. For τ, replace the battery with a wire and look out from the capacitor.
Check yourself
Three identical bulbs: A is in series with the battery, and B and C are in parallel with each other after A. Bulb C is unscrewed. What happens to the brightness of A and B?
  1. AA dims, B brightens.
  2. BA brightens, B dims.
  3. CBoth brighten.
  4. DBoth dim.
Show the answer

A. Removing C removes a parallel path, so the total resistance rises from 1.5R to 2R and the battery current drops: A, which carries all of it, dims. But B now gets all of that current instead of half: $\frac{\varepsilon}{2R}$ versus $\frac{\varepsilon}{3R}$ before, so B brightens. The trap is "both dim", which forgets that B's share grew.

Check yourself
A 5.0 μF capacitor is charged to 20 V and then connected across an uncharged 15 μF capacitor. What is the final voltage across them?
  1. A5.0 V
  2. B10 V
  3. C15 V
  4. D20 V
Show the answer

A. Charge is conserved: $Q = (5.0\ \mu\text{F})(20\ \text{V}) = 100\ \mu$C, shared by the two capacitors, which are now in parallel (20 μF): $V = \frac{100}{20} = 5.0$ V. The trap is 10 V, which averages the voltages instead of sharing the charge. (Energy is not conserved here: some becomes heat in the wires.)

Mr. Thompkins
That's Unit 11. Go try the Unit 11 practice set now, while it's fresh. When you miss one, come back to that section and open its recall cards. See you in Unit 12, where moving charges start making magnetic fields.