AP Physics C: E&M · Unit 10 · 10-15% of the exam · about 92 minutes

Unit 10: Conductors and Capacitors

By the end: Explain why conductors in equilibrium have zero interior field and a single potential, predict how charge spreads over and between conductors, derive capacitance for plate, spherical and cylindrical geometries, and find stored energy and the effect of a dielectric with the battery connected or disconnected.

Mr. Thompkins
  1. 10.1 Electrostatics with conductors · 9 min

    Why the field inside metal is zero

    • In equilibrium: E = 0 inside the conductor's material.
    • Excess charge lives on the surface.
    • The conductor is an equipotential (constant V, not necessarily zero).
  2. 10.1 Electrostatics with conductors: graphs · 7 min

    E and V for a charged metal sphere

    • Metal sphere: E = 0 inside, kQ/r² outside, jump of kQ/R² at the surface.
    • V = kQ/R everywhere inside, kQ/r outside. V is continuous.
    • E jumps at a surface charge; V never jumps.
  3. 10.1 Electrostatics with conductors: cavities and shielding · 10 min

    Hollow conductors and the Faraday cage

    • Charge q in a cavity induces −q on the inner surface.
    • Outer surface charge = shell total − inner surface charge (conservation).
    • An empty cavity in a conductor has E = 0, whatever is outside: shielding.
  4. 10.2 Redistribution of charge between conductors · 10 min

    Sharing charge until the potentials match

    • Connected conductors reach the same potential; total charge is conserved.
    • Far-apart spheres: $q \propto R$, and $\sigma \propto 1/R$.
    • Charge density and field are largest at sharp points.
  5. 10.3 Capacitors · 10 min

    Capacitance: charge per volt

    • $C = Q/\Delta V$: farads (C/V). Q is the charge on either plate.
    • Parallel plates: $E = Q/(\varepsilon_0A)$, $\Delta V = Ed$, $C = \varepsilon_0A/d$.
    • C depends only on geometry and material, never on Q or ΔV.
  6. 10.3 Capacitors: spherical and cylindrical · 10 min

    Capacitors that aren't flat

    • Recipe: Gauss for E between conductors, $\Delta V = \int E\,dr$, $C = Q/\Delta V$.
    • Cylindrical: $C = 2\pi\varepsilon_0L/\ln(b/a)$. Spherical: $C = 4\pi\varepsilon_0ab/(b - a)$.
    • Isolated sphere: $4\pi\varepsilon_0R$. Thin gaps reduce to $\varepsilon_0A/d$.
  7. 10.3 Capacitors: stored energy · 10 min

    Energy stored in a capacitor

    • $U_C = \frac{Q^2}{2C} = \frac{1}{2}Q\Delta V = \frac{1}{2}C(\Delta V)^2$: the area under V against q.
    • Energy density: $u_E = \frac{1}{2}\varepsilon_0E^2$. The energy lives in the field.
    • Disconnected: Q fixed, use Q²/2C. Connected: ΔV fixed, use ½CV².
  8. 10.3 Capacitors: a first look at combinations (Unit 11) · 7 min

    Capacitors in series and in parallel

    • Parallel: same ΔV, charges add, $C_p$ = C₁ + C₂.
    • Series: same Q, voltages add, $1/C_s = 1/C_1 + 1/C_2$. $C_s$ is smaller than either.
    • Full treatment in circuits comes in Unit 11.
  9. 10.4 Dielectrics · 10 min

    What an insulator in the gap does

    • Dielectric: bound surface charge reduces the field inside to $E_0/\kappa$.
    • $C = \kappa\varepsilon_0A/d$: a dielectric multiplies C by κ.
    • Connected (V fixed): Q and U go up by κ. Disconnected (Q fixed): V, E and U go down by κ.
  10. Unit 10 wrap-up · 9 min

    Put it together