10.4 DielectricsWhat an insulator in the gap does

An insulator placed in a field polarizes (Unit 8): its molecules stretch or rotate so their negative ends point toward the positive plate. Inside the material those little dipoles cancel each other, but at the surfaces they don't: a layer of bound negative charge appears on the face next to the positive plate, and a layer of bound positive charge on the face next to the negative plate.
?Wait, what is polarization again?
The bound charges make a field opposite the plates' field, so the field inside the dielectric is smaller. For a material with dielectric constant κ (kappa, always at least 1; vacuum is exactly 1, air about 1.0006), the field is reduced by a factor of κ: $E = E_0/\kappa$. For the same free charge on the plates, ΔV = Ed is smaller by κ, so the capacitance is bigger by κ:
$$C = \kappa C_0 = \frac{\kappa\varepsilon_0A}{d}$$
That's the whole effect: a dielectric multiplies capacitance by κ. Dielectrics also help in a practical way: they keep the plates apart and resist sparking, so a capacitor can be built with a tiny gap.
I thought about it. Show me
| Change | Battery connected (V fixed) | Battery disconnected (Q fixed) |
|---|---|---|
| Insert dielectric κ | C × κ, Q × κ, V same, E same, U × κ | C × κ, Q same, V ÷ κ, E ÷ κ, U ÷ κ |
| Double the plate gap d | C ÷ 2, Q ÷ 2, V same, E ÷ 2, U ÷ 2 | C ÷ 2, Q same, V × 2, E same, U × 2 |
| Double the plate area A | C × 2, Q × 2, V same, E same, U × 2 | C × 2, Q same, V ÷ 2, E ÷ 2, U ÷ 2 |
- Disconnected: Q stays at 2.1 nC.
- $C = \kappa C_0 = 3.0(177) = 531$ pF. $\Delta V = Q/C = 12/3.0 = 4.0$ V.
- $U = \frac{Q^2}{2C}$ with Q fixed and C tripled: $U = \frac{1.27 \times 10^{-8}}{3} = 4.2 \times 10^{-9}$ J.
- The energy dropped by $8.5 \times 10^{-9}$ J. The field pulls the slab into the gap (the bound charges are attracted to the plates), doing positive work on it. If nobody holds the slab back, it speeds up as it goes in.
Why?
Energy lost by the field equals the work the field does on the slab.
Answer: C = 531 pF, Q unchanged, ΔV = 4.0 V, U = $4.2 \times 10^{-9}$ J (one third). The field did work pulling the slab in.
Stuck? Get a hint
- Disconnected means Q is fixed.
- C goes up by κ, so ΔV = Q/C goes down by κ.
- U = Q²/2C goes down by κ.
I thought about it. Show me
?Wait, why doesn't κ have units?
Real materials have limits. Every insulator has a dielectric strength, the largest field it can take before it breaks down and conducts (about $3 \times 10^6$ V/m for dry air). A spark across a capacitor's gap is exactly that breakdown. Good dielectrics both raise C and tolerate stronger fields, so a capacitor can store more energy in less space. (The specific numbers are beyond the course, as a bonus; the idea that a field can be strong enough to ionize a material is the same one behind sparks at sharp points.)
- AIt doubles.
- BIt halves.
- CIt stays the same.
- DIt drops to zero inside the slab.
Show the answer
B. With Q fixed, the bound charge cancels part of the plates' field, leaving $E = E_0/\kappa = E_0/2$. It doesn't drop to zero: a dielectric is not a conductor.
Partly filled capacitors
If a slab fills only part of the gap, think of the capacitor as two capacitors. A slab filling half the plate area, side by side with vacuum, makes two capacitors with the same ΔV: parallel. A slab filling half the gap's thickness, stacked against vacuum, makes two capacitors with the same Q: series.
- (a) Two capacitors in parallel, each with area A/2 and gap d: $\frac{C_0}{2}$ (vacuum) and $\kappa\frac{C_0}{2}$ (slab).
- $C = \frac{C_0}{2} + \frac{4.0\,C_0}{2} = 2.5\,C_0$.
- (b) Two capacitors in series, each with area A and gap d/2: $2C_0$ (vacuum) and $2\kappa C_0 = 8C_0$ (slab).
Why?
Halving the gap doubles C. - $\frac{1}{C} = \frac{1}{2C_0} + \frac{1}{8C_0} = \frac{5}{8C_0}$, so $C = 1.6\,C_0$.
Answer: (a) $2.5\,C_0$. (b) $1.6\,C_0$.
- AC increases, Q increases, ΔV unchanged
- BC increases, Q unchanged, ΔV decreases
- CC decreases, Q decreases, ΔV unchanged
- DC unchanged, Q increases, ΔV increases
Show the answer
A. The battery fixes ΔV. The dielectric multiplies C by κ, so Q = CΔV grows. The second choice is the disconnected case.

Make the connected/disconnected decision in writing, in your first line: "The battery is disconnected, so Q is constant." It earns credit on its own and steers every equation after it.
- Dielectric: bound surface charge reduces the field inside to $E_0/\kappa$.
- $C = \kappa\varepsilon_0A/d$: a dielectric multiplies C by κ.
- Connected (V fixed): Q and U go up by κ. Disconnected (Q fixed): V, E and U go down by κ.
- Partial fill: side by side is parallel; stacked layers are series.