AP Physics C: E&M · Unit 10 lecture · Part 10 of 10 · 9 min
Unit 10 wrap-upPut it together

Mr. Thompkins
That's the unit. Two ideas run through all of it: a conductor in equilibrium is a field-free equipotential, and a capacitor is two conductors whose charge-to-voltage ratio is fixed by geometry. Everything else is Gauss's law and $\Delta V = -\int\vec E\cdot d\vec r$, which you already own.
Conductors
- E = 0 inside the metal
- Charge on the surfaces
- One potential everywhere
- Just outside: $E = \sigma/\varepsilon_0$, perpendicular
Capacitors
- $C = Q/\Delta V$, set by geometry
- Plates: $\varepsilon_0A/d$, times κ with a dielectric
- $U = Q^2/2C = \tfrac{1}{2}C(\Delta V)^2$
- First question: connected (V fixed) or not (Q fixed)?
?Wait, why is a capacitor's plate an equipotential?
Each plate is a conductor in equilibrium, so the whole plate sits at one potential. That's why "the voltage across a capacitor" is a single number: the difference between the two plates' potentials.
?Wait, which Gaussian surface goes with which capacitor?
Parallel plates: a pillbox through one plate. Coaxial: a cylinder between the conductors. Spherical: a sphere between the shells. Same matching as in Unit 8: the surface copies the symmetry.
Pause and think
A charged, isolated parallel-plate capacitor has its plates pushed closer together. Do the plates attract or repel, and does the stored energy go up or down?
I thought about it. Show me
They attract (opposite charges). Q is fixed and C rises as d falls, so $U = Q^2/2C$ goes down. The field does positive work pulling the plates together, and that work comes out of the stored energy.
Traps that cost points
✕ Saying V = 0 inside a conductor because E = 0.
✓ E = 0 means V is constant, equal to the surface value.
✕ Using σ/(2ε₀) just outside a conductor.
✓ Conductor: σ/ε₀. Insulating sheet: σ/(2ε₀).
✕ Splitting charge equally between connected conductors of different sizes.
✓ They share until their potentials match: q ∝ R for spheres.
✕ Thinking C depends on Q or ΔV.
✓ C depends only on geometry and the dielectric.
✕ Forgetting to check whether the battery is connected.
✓ Connected: ΔV fixed. Disconnected: Q fixed. Decide first.
✕ Writing U = QΔV.
✓ U = ½QΔV: the charge crosses an average of half the final voltage.
✕ Combining capacitors like resistors.
✓ Parallel capacitors add directly; series capacitors add as reciprocals.
| Capacitor | Capacitance | Depends on |
|---|---|---|
| Parallel plates | $\kappa\varepsilon_0 A/d$ | Area, gap, material |
| Spherical (radii a < b) | $4\pi\varepsilon_0 ab/(b-a)$ | Both radii |
| Cylindrical (radii a < b, length L) | $2\pi\varepsilon_0 L/\ln(b/a)$ | Length, ratio of radii |
| Isolated sphere, radius R | $4\pi\varepsilon_0 R$ | Radius (other plate at infinity) |
Key relationships for Unit 10
$E_{inside} = 0, \quad E_{surface} = \frac{\sigma}{\varepsilon_0}$
Conductor in equilibriumE just outside is perpendicular
$\frac{q_A}{q_B} = \frac{R_A}{R_B}$
Connected spheresFrom $V_A$ = $V_B$
$C = \frac{Q}{\Delta V}$
CapacitanceFarads; geometry only
$C = \frac{\kappa\varepsilon_0A}{d}$
Parallel platesκ = 1 for vacuum
$C = \frac{2\pi\varepsilon_0L}{\ln(b/a)}, \ C = \frac{4\pi\varepsilon_0ab}{b-a}$
Cylindrical and sphericalGauss, then integrate
$U_C = \frac{Q^2}{2C} = \frac{1}{2}C(\Delta V)^2$
Stored energyArea under V against q
$u_E = \frac{1}{2}\varepsilon_0E^2$
Energy densityEnergy stored in any field
FRQ strategy for Unit 10
- Start every conductor argument with "in electrostatic equilibrium, E = 0 inside the conductor", then use Gauss's law with a surface inside the metal.
- Mathematical Routines: derive C in three labeled steps (E from Gauss, ΔV from the integral, C = Q/ΔV) and check that Q cancels.
- Qualitative/Quantitative Translation: for "what happens if..." questions, state what is fixed (Q or ΔV), then go through C, Q, ΔV, E and U one at a time with the formula that justifies each.
- Translation Between Representations: E against r for conductors is zero inside with a jump at each charged surface; V is flat inside and continuous.
- Experimental Design and Analysis: to find ε₀ or κ, vary d (or A), measure C, and graph C against 1/d (or A). The slope is ε₀A (or κε₀ with a dielectric).
Mixed FRQ practice
A student measures the capacitance of two square plates, 0.040 m² each, at several separations d, with air between them, and finds that a graph of C against 1/d is a straight line with slope $3.5 \times 10^{-13}$ F·m. (a) Use the slope to find a value for ε₀. (b) The plates are then held 2.0 mm apart, charged to 50 V and disconnected. Find the stored energy. (c) A κ = 2.5 slab is slid in to fill the gap. Find the new voltage and explain whether the student must push the slab in or hold it back.
- (a) $C = \varepsilon_0A\cdot\frac{1}{d}$, so the slope is $\varepsilon_0A$: $\varepsilon_0 = \frac{3.5 \times 10^{-13}}{0.040} = 8.75 \times 10^{-12}\ \text{C}^2/(\text{N·m}^2)$.
Why?
Linearize: graph C against 1/d, and the slope carries the constant you want. - (b) Using the measured value: $C = \frac{(8.75 \times 10^{-12})(0.040)}{2.0 \times 10^{-3}} = 1.75 \times 10^{-10}$ F, and $U = \tfrac{1}{2}(1.75 \times 10^{-10})(50)^2 = 2.2 \times 10^{-7}$ J.
- (c) Disconnected, so Q is fixed and C rises by 2.5: $\Delta V = 50/2.5 = 20$ V.
- U drops (Q fixed, C up), so the field does positive work on the slab: it pulls the slab in. The student must hold it back to slide it in slowly.
Answer: (a) $8.8 \times 10^{-12}\ \text{C}^2/(\text{N·m}^2)$, close to the accepted $8.85 \times 10^{-12}$. (b) $2.2 \times 10^{-7}$ J. (c) 20 V; the slab is pulled in, so the student holds it back.
Stuck? Get a hint
- C = ε₀A(1/d): the slope of C against 1/d is ε₀A.
- U = ½CV² before the slab goes in.
- Disconnected: Q fixed, so V = Q/C falls by κ, and so does U.
Check yourself
A point charge +q sits off-center inside the cavity of a neutral spherical metal shell. How is the charge on the shell's outer surface distributed?
- AUniformly, +q in total
- BBunched on the side nearest the charge, +q in total
- CUniformly, −q in total
- DThere is no charge on the outer surface
Show the answer
A. The inner surface charge (−q) bunches near the off-center charge, and together they make zero field in the metal. The outer surface, shielded from the cavity, sees only a spherical conductor carrying +q, so it spreads uniformly. The second choice confuses the inner surface with the outer one.
Check yourself
A capacitor connected to a battery has its plate separation halved. What happens to its stored energy?
- AIt halves.
- BIt stays the same.
- CIt doubles.
- DIt quadruples.
Show the answer
C. Connected, so ΔV is fixed. Halving d doubles C, and $U = \tfrac{1}{2}C(\Delta V)^2$ doubles. Using $Q^2/2C$ with Q held fixed would wrongly predict that U halves.

Mr. Thompkins
That's Unit 10, and with it all of electrostatics. Go take the Unit 10 practice set, and when one trips you up, come back to that section's recall cards. Next up, Unit 11: circuits, where capacitors finally get to charge and discharge.