AP Physics C: E&M · Unit 10 lecture · Part 2 of 10 · 7 min

10.1 Electrostatics with conductors: graphsE and V for a charged metal sphere

Mr. Thompkins
Graphs of E and V against r are free points on the exam if you know the shapes. The conducting sphere is the one to master first, because every other conductor problem is a variation of it.

Take a solid metal sphere (or a hollow metal shell, it doesn't matter) of radius R with charge Q. All the charge is on the surface. Inside, E = 0. Outside, by Gauss's law, it acts like a point charge: $E = kQ/r^2$. So E jumps from 0 to $kQ/R^2$ right at the surface, where the surface charge sits.

The potential outside is $kQ/r$. Inside, E = 0, so V doesn't change as you go in: it stays at the surface value $kQ/R$ all the way to the center. V is continuous everywhere (it never jumps), but its slope jumps at the surface, matching the jump in E.

?Wait, what did the uniform insulating ball look like?
From Units 8 and 9: inside a uniformly charged insulating ball, $E = kQr/R^3$ grows linearly from zero, and V is a downward parabola, highest at the center ($1.5\,kQ/R$). Outside, the ball and the metal sphere look identical: both are like a point charge.
00.050.10.150.20.250.302000400060008000$r$ (m)$E$ (N/C)inside: 0$kQ/r^2$surfacejumps to 7200
E for a metal sphere (Q = 8.0 nC, R = 0.10 m). Zero inside, a jump at the surface, then 1/r².
00.050.10.150.20.250.30200400600800$r$ (m)$V$ (V)constant: 720 V$kQ/r$
V for the same sphere. Flat at 720 V inside, then kQ/r outside. No jump in V.

Compare that with the insulating ball you met in Units 8 and 9. Same total charge, same radius, same outside graphs. The only difference is where the charge sits. In the metal sphere, the charge has all run to the surface, so a Gaussian sphere inside encloses nothing. In the insulating ball, the charge is stuck throughout the volume, so a Gaussian sphere inside encloses some of it. On the exam, the words "conducting" and "insulating" are telling you which graph to draw.

Pause and think
Why can E jump at the surface while V cannot?
I thought about it. Show me
E jumps wherever a surface charge sits (Gauss's law with a thin pillbox). V is the integral of E, and integrating a finite jump over a zero distance adds nothing, so V stays continuous. A jump in V would need an infinite field.
Conducting sphere: E and V
The sphere above has $Q = 8.0$ nC and $R = 0.10$ m. Find E and V at (a) r = 0.050 m and (b) r = 0.20 m.
  1. (a) Inside the metal: $E = 0$.
  2. V inside equals the surface value: $V = \frac{kQ}{R} = \frac{(9.0 \times 10^9)(8.0 \times 10^{-9})}{0.10} = 720$ V.
    Why?
    No field inside, so no change in V from the surface to the center.
  3. (b) Outside: $E = \frac{kQ}{r^2} = \frac{72}{(0.20)^2} = 1800$ N/C, outward, and $V = \frac{kQ}{r} = \frac{72}{0.20} = 360$ V.

Answer: (a) E = 0, V = 720 V. (b) E = 1800 N/C, V = 360 V.

Stuck? Get a hint
  1. Inside a conductor E = 0, always.
  2. V inside equals V at the surface: kQ/R.
  3. Outside, use the point-charge formulas.
?Wait, why is V = kQ/r outside?
Integrate the field in from infinity: $V(r) = -\int_\infty^r\frac{kQ}{r'^2}dr' = \frac{kQ}{r}$. Outside, only the total charge matters, so any spherical charge gives the same V.
Check yourself
A hollow metal sphere of radius R carries charge Q. What is the potential at its center (V = 0 at infinity)?
  1. A0
  2. B$kQ/R$
  3. C$kQ/(2R)$
  4. D$1.5\,kQ/R$
Show the answer

B. Inside the conductor's cavity (with no charge in it) E = 0, so V equals the surface value $kQ/R$. $1.5\,kQ/R$ is the center of a uniformly charged insulating ball, and 0 is the classic "zero field means zero potential" trap.

Exam tip from Mr. T

When you sketch E or V against r for a conductor, mark the surface radius first. E: zero inside, a jump at the surface. V: flat inside, continuous at the surface, then curving down as 1/r.

  • Metal sphere: E = 0 inside, kQ/r² outside, jump of kQ/R² at the surface.
  • V = kQ/R everywhere inside, kQ/r outside. V is continuous.
  • E jumps at a surface charge; V never jumps.