6.1 Rotational kinetic energyThe energy of spinning

In Unit 3 you learned that a moving object has kinetic energy $K = \tfrac12 mv^2$. For a spinning wheel, the center of mass doesn't move, so $\tfrac12 Mv_{cm}^2 = 0$. But look closer. Every bit of the wheel is moving in a circle around the axle. The energy is there. It's just organized as rotation instead of travel.
?Wait, why is $v = r\omega$ again?
So let's add up the kinetic energy of every piece. Chop the object into tiny pieces of mass $m_i$, each at its own distance $r_i$ from the axis. Each piece has $\tfrac12 m_i v_i^2 = \tfrac12 m_i (r_i\omega)^2$. Add them: $K = \sum \tfrac12 m_i r_i^2\omega^2 = \tfrac12\left(\sum m_i r_i^2\right)\omega^2$. The sum in the parentheses is exactly the rotational inertia you met in Unit 5. So the kinetic energy of a spinning object is $K_{rot} = \tfrac12 I\omega^2$.
In calculus form, for a continuous object, the sum becomes an integral: $K = \int \tfrac12 v^2\,dm = \int \tfrac12 (r\omega)^2\,dm = \tfrac12\omega^2\int r^2\,dm = \tfrac12 I\omega^2$. The $\omega^2$ slides out of the integral because every piece shares the same $\omega$. That one line is the whole derivation, and it's worth being able to write on an FRQ that says "derive".
?Wait, what is rotational inertia again?
| Object | Axis | I |
|---|---|---|
| Point mass m at distance r | Any axis | mr² |
| Thin hoop or ring | Through center, perpendicular | MR² |
| Solid disk or cylinder | Through center, along its axis | ½MR² |
| Thin spherical shell | Through center | ⅔MR² |
| Solid sphere | Through center | ⅖MR² |
| Thin rod, length L | Through center, perpendicular | ML²/12 |
| Thin rod, length L | Through one end, perpendicular | ML²/3 |
Put the two formulas side by side: $\tfrac12 mv^2$ and $\tfrac12 I\omega^2$. The rotational one swaps mass for rotational inertia and speed for angular speed. That's the translation and rotation dictionary from Unit 5 again, and it will keep paying off all unit long: momentum $p = mv$ becomes $L = I\omega$, and force $F$ becomes torque $\tau$.
Many objects translate and rotate at the same time: a thrown football that spirals, a rolling tire, a tumbling wrench. For any rigid object, the total kinetic energy splits cleanly into two parts: $K = \tfrac12 Mv_{cm}^2 + \tfrac12 I_{cm}\omega^2$. The first term is the center of mass traveling. The second is spinning about the center of mass, with $I_{cm}$ measured about an axis through the center of mass. You'll use this split a lot in the rolling section.
I thought about it. Show me
- Convert the spin rate to rad/s: $\omega = 3000\ \frac{\text{rev}}{\text{min}} \times \frac{2\pi\ \text{rad}}{1\ \text{rev}} \times \frac{1\ \text{min}}{60\ \text{s}} = 314\ \text{rad/s}$.
Why?
$K = \tfrac12 I\omega^2$ came from $v = r\omega$, which needs radians. Plugging in 3000 or 50 gives a number that is wrong by a huge factor. - Rotational inertia of a solid disk about its axle: $I = \tfrac12 MR^2 = \tfrac12(12)(0.25)^2 = 0.375\ \text{kg}\cdot\text{m}^2$.
- (a) $K = \tfrac12 I\omega^2 = \tfrac12(0.375)(314.2)^2 = 1.85 \times 10^4\ \text{J}$.
Why?
Write the symbolic equation first, then substitute with units. Graders give a point for the correct starting equation even if arithmetic slips. - (b) Set $\tfrac12 m v^2 = 1.85 \times 10^4\ \text{J}$: $v = \sqrt{\frac{2(1.85 \times 10^4)}{1200}} = 5.55\ \text{m/s}$.
Why?
About 20 km/h. A wheel you could carry stores as much energy as a car rolling through a parking lot. That is why flywheels are used for energy storage.
Answer: (a) About $1.9 \times 10^4$ J. (b) About 5.6 m/s.
Stuck? Get a hint
- Change rev/min into rad/s first: multiply by 2π and divide by 60.
- Use $I = \tfrac12 MR^2$ for a solid disk.
- For (b), set $\tfrac12 mv^2$ equal to your answer from (a) and solve for v.
- Athe same
- Btwo times as large
- Cfour times as large
- Deight times as large
Show the answer
C. $I = \tfrac12 MR^2$, so doubling R makes I four times as large, and $K = \tfrac12 I\omega^2$ follows I. The top trap is "two times": R appears squared in I. Another trap is "eight times", from also doubling the rim speed; that faster rim is already counted inside the $R^2$.
- Rotational kinetic energy: $K_{rot} = \tfrac12 I\omega^2$, from $K = \int\tfrac12 v^2\,dm$ with $v = r\omega$. Use $\omega$ in rad/s.
- For the same mass and size, the object with more mass far from the axis (larger I) stores more energy at the same ω.
- A rigid object that moves and spins: $K = \tfrac12 Mv_{cm}^2 + \tfrac12 I_{cm}\omega^2$.