AP Physics C: Mechanics · Unit 3 lecture · Part 6 of 9 · 9 min

3.4 Conservation of energyEnergy is never lost, only moved

Mr. Thompkins
Here's the payoff of the whole unit. Put kinetic and potential energy together, add one bookkeeping rule, and you can solve problems that would take pages with forces, like a block sliding down a curvy track into a spring, in about three lines.

Choose a system. If no external forces do work on it and no friction acts inside it, its mechanical energy stays constant:

$$K_i + U_i = K_f + U_f$$

Here $U$ means every potential energy in the system: gravity, springs, all of them. The general bookkeeping rule, which always works, is

$$W_{ext} = \Delta K + \Delta U + \Delta E_{th}$$

Energy that enters the system as external work shows up as kinetic, potential or thermal energy. When $W_{ext} = 0$ and there's no friction, $\Delta E_{th} = 0$ and you get back the first equation. This is one of the deepest laws in physics: energy is never created or destroyed, only moved between forms and between systems.

?Wait, why doesn't the shape of the track matter?
Gravity is conservative, so its work depends only on the change in height. A frictionless track's normal force is perpendicular to the motion, so it does no work. That means the speed at the bottom depends only on how far the block dropped, whether the track is steep, curvy or gentle. Only the time it takes depends on the shape.
0.50 kg1.2 mk = 400 N/mfrictionless
A 0.50 kg block released from rest 1.2 m up a frictionless track runs into a spring at the bottom.
Track into a spring
In the figure, the block (0.50 kg) starts from rest 1.2 m above the floor. The track and floor are frictionless, and the spring has $k = 400\ \text{N/m}$. Find (a) the block's speed at the bottom, before it reaches the spring, and (b) the maximum compression of the spring.
  1. System: block, Earth and spring. No friction, no external work, so $K + U_g + U_s$ is constant.
    Why?
    Naming the system and stating why energy is conserved is often its own point on an FRQ.
  2. (a) Top to bottom: $mgh = \frac12 mv^2$, so $v = \sqrt{2gh} = \sqrt{2(9.8)(1.2)} = 4.85\ \text{m/s}$.
    Why?
    The mass cancels, because both energies are proportional to m.
  3. (b) Top to maximum compression, where the block stops for an instant: $mgh = \frac12 kx^2$.
    Why?
    Go straight from the top. You do not need the speed at the bottom at all.
  4. $x = \sqrt{\frac{2mgh}{k}} = \sqrt{\frac{2(0.50)(9.8)(1.2)}{400}} = \sqrt{\frac{11.76}{400}} = 0.17\ \text{m}$.
    Why?
    Here the mass does not cancel: the spring energy has no m in it.

Answer: (a) about 4.85 m/s (b) about 0.17 m

Stuck? Get a hint
  1. Write K + U at the start and at the end. At the start, only Ug.
  2. At the bottom, only K. At maximum squeeze, only Us.
  3. mgh = ½kx², so x = √(2mgh/k).
TopK5.88UgUsBottom5.88KUgUsMax squeezeKUg5.88Us
Energy bar charts at three moments. The total is 5.88 J every time; only the form changes.
Pause and think
Two blocks, one twice as heavy, slide down the same frictionless track from the same height. Which is faster at the bottom? Which compresses the spring more?
I thought about it. Show me
Same speed, $\sqrt{2gh}$: the mass cancels. But the heavier block compresses the spring more, by a factor of $\sqrt2$, because it brings twice the energy and the spring's energy $\frac12 kx^2$ doesn't depend on the block's mass. "Mass cancels" is true for speeds, not for every answer.
?Wait, how do I draw an energy bar chart correctly?
Draw one bar per form of energy (K, Ug, Us, Eth) at each moment, with heights to scale. A bar of zero gets no height but keep its label. The totals at each moment must match, plus any external work in between. Graders check that the bars are consistent with your equations.
Check yourself
A ball is dropped from rest from a height of 5.0 m. Ignoring air resistance, how fast is it moving just before it hits the ground?
  1. A4.9 m/s
  2. B7.0 m/s
  3. C9.9 m/s
  4. D98 m/s
Show the answer

C. $mgh = \frac12 mv^2$, so $v = \sqrt{2gh} = \sqrt{2(9.8)(5.0)} = 9.9\ \text{m/s}$. Choice B forgets the 2 inside the root. Choice D is $v^2$, the step before taking the square root.

  • No friction, no external work: $K_i + U_i = K_f + U_f$, with every U in the system.
  • Always true: $W_{ext} = \Delta K + \Delta U + \Delta E_{th}$.
  • Write the energy at two moments you choose wisely. Skip the middle if you do not need it.
  • Mass cancels for speeds, not for spring compressions.