AP Physics C: E&M · Unit 13 lecture · Part 6 of 10 · 9 min

13.4 InductanceA coil that resists change

Mr. Thompkins
Here's a twist. A coil carrying current makes a magnetic field through its own turns. Change the current and you change that flux, so the coil induces an emf in itself. It fights its own changes, like a heavy flywheel that resists speeding up or slowing down.

The inductance of a coil is the flux linkage per unit current: $L = \frac{N\Phi_B}{I}$, in henries (1 H = 1 V·s/A = 1 Wb/A). Since the flux is proportional to the current, L depends only on the coil's shape and what's inside it, not on the current. Faraday's law then gives the self-induced emf: $\varepsilon_L = -N\frac{d\Phi}{dt} = -L\frac{dI}{dt}$. It opposes the change: it pushes back against a rising current and tries to keep a falling one going.

?Wait, what's the field inside a long solenoid?
$B = \mu_0 nI$, uniform, where $n = \frac{N}{\ell}$ is the number of turns per meter. You derived it with Ampère's law in Unit 12.

For a long solenoid of N turns, length ℓ and cross-sectional area A: the field is $\mu_0\frac{N}{\ell}I$, each turn has flux $\mu_0\frac{N}{\ell}IA$, and N turns give $N\Phi = \frac{\mu_0 N^2A}{\ell}I$. So $L = \frac{\mu_0 N^2A}{\ell}$. Inductance grows as N², because doubling the turns doubles the field and doubles the number of turns it threads.

A solenoid inductor
A solenoid has 800 turns, radius 1.5 cm and length 40 cm. (a) Find its inductance from $L = \frac{N\Phi}{I}$ by assuming a current of 4.0 A. (b) Find the emf when the current rises at 50 A/s. (c) Find the energy stored when it carries 4.0 A.
  1. (a) $B = \mu_0\frac{N}{\ell}I = (4\pi \times 10^{-7})(2000)(4.0) = 1.0 \times 10^{-2}$ T. $A = \pi(0.015)^2 = 7.07 \times 10^{-4}\ \text{m}^2$, so $\Phi = BA = 7.1 \times 10^{-6}$ Wb per turn.
    Why?
    This is the general recipe for any shape: assume a current, find B, find the flux through one turn, multiply by N, divide by I.
  2. $L = \frac{N\Phi}{I} = \frac{(800)(7.11 \times 10^{-6})}{4.0} = 1.4 \times 10^{-3}$ H, the same as $\frac{\mu_0 N^2A}{\ell}$. The 4.0 A cancels.
  3. (b) $|\varepsilon| = L\frac{dI}{dt} = (1.42 \times 10^{-3})(50) = 0.071$ V.
  4. (c) $U = \frac{1}{2}LI^2 = \frac{1}{2}(1.42 \times 10^{-3})(4.0)^2 = 0.011$ J.

Answer: (a) 1.4 mH (b) 0.071 V (c) 0.011 J.

Stuck? Get a hint
  1. B = μ₀(N/ℓ)I inside the solenoid.
  2. Flux per turn is B times πr². Multiply by N and divide by I.
  3. Energy: ½LI².

Energy in an inductor

Pushing current into an inductor takes work, because you're pushing against its back emf. The power delivered is $P = I\cdot L\frac{dI}{dt}$, so the energy stored when the current reaches I is $U_L = \int_0^I LI'\,dI' = \frac{1}{2}LI^2$. That energy lives in the magnetic field. (Beyond the course, as a bonus: its density is $\frac{B^2}{2\mu_0}$, the twin of $\frac{1}{2}\varepsilon_0E^2$.)

?Wait, what was the energy in a capacitor?
$U_C = \frac{1}{2}C(\Delta V)^2 = \frac{q^2}{2C}$, stored in the electric field between the plates. The inductor's $\frac{1}{2}LI^2$ is its magnetic partner, and in Topic 13.6 energy will slosh between the two.
01234567800.511.522.53t (ms)I (A)
Current through a 0.050 H inductor: rising for 4 ms, steady for 2 ms, then dropping to zero in 1 ms.
012345678-120-100-80-60-40-2002040t (ms)$L\,dI/dt$ (V)25 V−100 V
The inductor's voltage follows the slope of the current: L dI/dt = 25 V while rising, 0 while steady, −100 V during the fast drop.
Pause and think
In the graphs above, why is the voltage four times bigger (and reversed) during the drop than during the rise?
I thought about it. Show me
The current falls 2 A in 1 ms, a rate of 2000 A/s, four times faster than it rose (500 A/s). The voltage is $L\frac{dI}{dt}$, so it's four times bigger, and negative because the current is decreasing. A sudden cut in current gives a big voltage spike.
Check yourself
A solenoid is rewound with three times as many turns on the same length and the same cross-section. By what factor does its inductance change?
  1. A9
  2. B3
  3. C1
  4. D1/3
Show the answer

A. $L = \frac{\mu_0 N^2A}{\ell} \propto N^2$, so ×9. The trap is 3, which counts only that there are more turns, not that each turn also sees three times the field.

Check yourself
An inductor carries a steady 3.0 A. What is the voltage across an ideal inductor?
  1. AZero
  2. BL times 3.0 A
  3. CIt depends on L only
  4. DInfinite
Show the answer

A. $V_L = L\frac{dI}{dt}$, and a steady current has $\frac{dI}{dt} = 0$. An ideal inductor with steady current acts like a plain wire. Choice B confuses current with its rate of change.

  • $L = \frac{N\Phi_B}{I}$ (henries); $\varepsilon_L = -L\frac{dI}{dt}$.
  • Long solenoid: $L = \frac{\mu_0 N^2A}{\ell}$, proportional to N².
  • Energy: $U_L = \frac{1}{2}LI^2$, stored in the magnetic field.
  • An inductor opposes changes in current, not current itself.