AP Physics C: E&M · Unit 13 lecture · Part 2 of 10 · 9 min

13.2 Electromagnetic induction: Faraday's lawChange the flux, get an emf

Mr. Thompkins
Here's the experiment that changed the world. Michael Faraday wound a coil, connected it to a meter, and pushed a magnet in. The needle jumped. He held the magnet still inside the coil: nothing. He pulled it out: the needle jumped the other way. The magnet being there does nothing. The magnet moving does everything.

Faraday's law: the emf induced around a loop equals the rate of change of the magnetic flux through it, $\varepsilon = -\frac{d\Phi_B}{dt}$. For a coil of N turns, each turn adds its own emf: $\varepsilon = -N\frac{d\Phi_B}{dt}$, with $\Phi_B$ the flux through one turn. The minus sign carries the direction, which is Lenz's law, next section. For sizes, use $|\varepsilon| = N\left|\frac{d\Phi_B}{dt}\right|$.

?Wait, what's an emf again?
Emf is the work done per unit charge in pushing charge around a loop, in volts. In Unit 11 a battery supplied it by chemistry. Here a changing magnetic flux supplies it. Either way, it drives a current $I = \frac{\varepsilon}{R}$ if the loop has resistance R.

Because $\Phi_B = BA\cos\theta$, there are three ways to change it, and each one induces an emf: change the field's strength, change the loop's area (or how much of it sits in the field), or change the angle, by rotating the loop. A large but constant flux induces nothing at all.

012345602468t (s)Φ (mWb)
The flux through one loop: rising, steady, then falling quickly.
0123456-4-202468t (s)emf (mV)−3 mV+6 mV
The emf is minus the slope of the flux graph: −3 mV while it rises, zero while steady, +6 mV while it falls twice as fast.
?Wait, how do I get a rate from a graph?
The rate of change of a quantity is the slope of its graph against time. A straight segment has a constant slope: rise over run. So on a flux graph, a steep segment means a large emf, and a flat segment means zero emf, however high it sits.
Pause and think
On the flux graph above, during which interval is the size of the emf biggest, and why is it zero from 2 s to 4 s even though the flux is at its largest then?
I thought about it. Show me
Biggest from 4 s to 5 s, where the flux falls 6 mWb in 1 s, the steepest slope. From 2 to 4 s the flux is large but not changing, and only change counts.
A coil in a growing field
A flat coil of 60 turns, radius 4.0 cm and total resistance 1.5 Ω, lies perpendicular to a uniform field that varies as $B(t) = 0.20 + 0.15t^2$ (T, with t in s). Find (a) the flux through one turn at t = 2.0 s, (b) the emf at t = 2.0 s, and (c) the induced current at that moment.
  1. (a) $A = \pi(0.040)^2 = 5.03 \times 10^{-3}\ \text{m}^2$. $\Phi = BA = (0.20 + 0.15 \cdot 4.0)(5.03 \times 10^{-3}) = 4.0 \times 10^{-3}$ Wb.
  2. (b) $|\varepsilon| = NA\frac{dB}{dt}$ and $\frac{dB}{dt} = 0.30t = 0.60$ T/s at t = 2.0 s. So $|\varepsilon| = (60)(5.03 \times 10^{-3})(0.60) = 0.18$ V.
    Why?
    Differentiate first, then substitute t. The flux value from (a) plays no role: only its rate of change does.
  3. (c) $I = \frac{|\varepsilon|}{R} = \frac{0.181}{1.5} = 0.12$ A.

Answer: (a) $4.0 \times 10^{-3}$ Wb (b) 0.18 V (c) 0.12 A.

Stuck? Get a hint
  1. Area of one turn: πr² with r in meters.
  2. dB/dt = 0.30t. Put in t = 2.0 s.
  3. emf = N A dB/dt, then I = emf / R.

Generators

Spin a coil of N turns and area A at angular speed ω in a uniform field. Its angle grows as θ = ωt, so the flux per turn is $\Phi = BA\cos\omega t$, and Faraday's law gives $\varepsilon = -N\frac{d\Phi}{dt} = NBA\omega\sin\omega t$: an alternating emf with peak $NBA\omega$. A coil of 50 turns and 0.040 m² in a 0.25 T field spinning at 120 rad/s peaks at 60 V. Derive this from Faraday's law when asked: the CED lists the law, not the generator formula.

Faraday's law has a deeper meaning. A changing magnetic field creates an electric field, even with no wire there: $\oint \vec E \cdot d\vec\ell = -\frac{d\Phi_B}{dt}$. Its field lines close on themselves, so it is not conservative: the work around a loop is the emf, not zero, and you can't define a potential for it. Inside a long solenoid whose field changes at $\frac{dB}{dt}$, a circle of radius r gives $E(2\pi r) = \pi r^2\frac{dB}{dt}$, so $E = \frac{r}{2}\frac{dB}{dt}$. At r = 3.0 cm with dB/dt = 0.80 T/s, that's 0.012 V/m.

Check yourself
The flux through each turn of a 40-turn coil is $\Phi = 0.030t^2$ (Wb, t in s). What is the size of the emf at t = 3.0 s?
  1. A7.2 V
  2. B0.18 V
  3. C10.8 V
  4. D3.6 V
Show the answer

A. $|\varepsilon| = N\frac{d\Phi}{dt} = 40(0.060t) = 2.4t$, which is 7.2 V at 3.0 s. Choice B forgets the 40 turns. Choice C uses the flux itself, $40(0.030)(9.0)$, instead of its rate of change.

  • Faraday: $\varepsilon = -N\frac{d\Phi_B}{dt}$. Only a change in flux induces an emf.
  • Three levers: change B, change the area in the field, or change the angle.
  • emf against t is minus the slope of the Φ against t graph.
  • A rotating coil gives $NBA\omega\sin\omega t$. A changing B makes a non-conservative electric field.