AP Physics C: E&M · Unit 12 lecture · Part 5 of 10 · 8 min

12.2 Magnetic forces on currentsForces on wires

Mr. Thompkins
A current is just a crowd of moving charges, so a wire carrying current in a magnetic field feels a force. That's the force that spins every electric motor and pushes every speaker cone. Let's get it from the force on one charge.

Take a straight piece of wire of length L carrying current I in a uniform field. The moving charges inside each feel $q\vec v_d \times \vec B$. Adding them up gives $\vec F = I\vec L \times \vec B$, where $\vec L$ points along the current. Its size is $ILB\sin\theta$, with θ between the wire and the field. For a curved wire, add the pieces: $\vec F = \int I\,d\vec\ell \times \vec B$.

?Wait, how does qv × B turn into IL × B?
A length L of wire with cross-section A holds $nAL$ carriers, each with charge q and drift velocity $\vec v_d$. Total force: $nALq\,\vec v_d \times \vec B$. Since $I = nqAv_d$ (Unit 11), that's $I\vec L \times \vec B$.
××××××××××××××××××××××××I$F_B$$mg$light flexible leads (dashed) carry the current in and out
A rod carrying current to the right in a field into the page. IL × B points up. If it balances mg, the rod floats.
Pause and think
Use the cycle: current to the right ($\hat x$), field into the page ($-\hat z$). Which way does $I\vec L \times \vec B$ point?
I thought about it. Show me
Up. $\hat x \times (-\hat z) = -(\hat x \times \hat z) = -(-\hat y) = +\hat y$. That's the upward force on the rod in the figure.
Float a rod
The rod in the figure is 0.25 m long with a mass of 0.030 kg, in a uniform 0.40 T field into the page, held only by light flexible leads. (a) What current, and in which direction, makes the rod float with the leads slack? (b) Draw the free-body diagram. (c) If the current is reversed, what is the tension in the two leads together?
  1. (a) The magnetic force must point up and balance gravity: $ILB = mg$, so $I = \frac{mg}{LB} = \frac{(0.030)(9.8)}{(0.25)(0.40)} = 2.9$ A, flowing to the right.
    Why?
    Check the direction with the cycle: $\hat x \times (-\hat z) = +\hat y$. Current to the left would push the rod down.
  2. (b) Two forces of equal length: $ILB$ up and $mg$ down, drawn from the rod's center. Nothing else touches it.
  3. (c) Reversed, the magnetic force points down: $F_B = (2.94)(0.25)(0.40) = 0.29$ N. The leads must hold $mg + F_B = 0.29 + 0.29 = 0.59$ N.
    Why?
    When the current flips, so does the force. Now the leads hold twice the rod's weight.

Answer: (a) 2.9 A to the right (b) $ILB$ up, $mg$ down, equal (c) 0.59 N.

$ILB$$mg$
Free-body diagram for the floating rod: the magnetic force balances gravity.
Stuck? Get a hint
  1. Floating means the net force is zero.
  2. Set ILB equal to mg and solve for I.
  3. Use x̂ × (−ẑ) to check which current direction pushes up.

Two useful shortcuts. In a uniform field, any curved wire running from point a to point b feels the same force as a straight wire from a to b: the force on a semicircular wire of radius r is $I(2r)B$, as if it were its diameter. And a closed loop in a uniform field feels zero net force, because the pieces cancel in pairs. (It can still feel a torque, which is how a motor turns.)

?Wait, what's torque?
Torque is the turning effect of a force: $\tau = rF\sin\theta$, the force times its lever arm. Two equal, opposite forces that don't act along the same line make zero net force but a nonzero torque. That pair is called a couple.
Check yourself
A straight wire 0.30 m long carries 5.0 A at 30° to a uniform 0.40 T field. What is the size of the force on it?
  1. A0.30 N
  2. B0.60 N
  3. C0.52 N
  4. DZero
Show the answer

A. $F = ILB\sin\theta = (5.0)(0.30)(0.40)\sin 30° = 0.30$ N. Choice B uses θ = 90°; choice C uses cos 30°.

Exam tip from Mr. T

Free-body diagrams for wires and rods: draw the magnetic force as a single arrow from the center, labeled with its formula ($F_B$ or ILB), and only the forces that actually act. An extra "centripetal" or "normal" arrow that doesn't exist costs the diagram point.

  • $\vec F = I\vec L \times \vec B$ (straight wire, uniform B); $\vec F = \int I\,d\vec\ell \times \vec B$ in general.
  • Size $ILB\sin\theta$, θ between the wire and B. $\vec L$ points along the current.
  • Uniform field: a curved wire from a to b feels the same force as the straight wire a to b. A closed loop feels zero net force.