AP Physics 1 · Unit 6 lecture · Part 6 of 11 · 8 min

6.4 Collisions with rotating objectsWhen the axle steals your momentum

Mr. Thompkins
What happens when a moving object hits something that can only spin? This is where linear momentum, which you trusted all through Unit 4, quietly fails, and angular momentum takes over.

Picture a child running along a line that just grazes the rim of a merry-go-round at rest, then jumping on. During the landing, the merry-go-round's axle holds it in place: the axle pushes on the merry-go-round with a large external force. So linear momentum of the child + merry-go-round system is not conserved. But the axle force acts at the axis, so it makes no torque about the axis. Angular momentum about the axle is conserved.

axle1.5 m4.0 m/schild, 40 kgdisk: 200 kgat rest at first
Top view: a 40 kg child runs at 4.0 m/s along a line tangent to the rim of a 200 kg, 1.5 m merry-go-round at rest, then jumps on at the rim.
?Wait, why does the axle force make no torque?
Torque is $r_\perp F$, and $r_\perp$ is measured from the axis. A force that acts at the axis has $r_\perp = 0$, so its torque is zero, however large it is. That's why we always take angular momentum about the axle in these problems.
?Wait, what's the rotational inertia of the child on the rim?
Treat the child as a point mass at the rim: $I = mr^2 = (40)(1.5)^2 = 90$ kg·m². Rotational inertias about the same axis add, so the total is the disk's $I$ plus 90.
Mathematical routine: angular momentum in a collision
For the child and merry-go-round above, with the merry-go-round a uniform disk ($I = \tfrac12MR^2$) on a frictionless axle: (a) find the angular velocity just after the child lands; (b) find the kinetic energy lost; (c) show that linear momentum is not conserved.
  1. System: child + merry-go-round. Axis: the axle. The axle force acts at the axis and the vertical forces are parallel to it, so the net external torque about the axle is zero and $L$ is conserved.
  2. Before: the child's $L = mvr_\perp = (40)(4.0)(1.5) = 240$ kg·m²/s. The disk's is zero.
    Why?
    The child's line of motion is tangent to the rim, so r⊥ is the radius.
  3. After: $I = \tfrac12(200)(1.5)^2 + (40)(1.5)^2 = 225 + 90 = 315$ kg·m². $\omega = \dfrac{240}{315} = 0.76$ rad/s.
  4. (b) $K_{before} = \tfrac12(40)(4.0)^2 = 320$ J. $K_{after} = \tfrac12(315)(0.762)^2 = 91$ J. About 229 J is lost, to internal energy, as in any sticking collision.
    Why?
    A child landing and sticking is a perfectly inelastic rotational collision.
  5. (c) Before: $p = (40)(4.0) = 160$ kg·m/s. After: the disk's center doesn't move, so its momentum is zero, and the child moves at $(0.762)(1.5) = 1.14$ m/s, so $p = 46$ kg·m/s. Not equal: the axle supplied an external impulse.

Answer: (a) About 0.76 rad/s. (b) About 229 J lost. (c) 160 kg·m/s before vs 46 kg·m/s after: the axle's impulse changed it.

Stuck? Get a hint
  1. Use angular momentum about the axle; the axle force has no torque.
  2. Child's $L = mvR$ with $R = 1.5$ m.
  3. Total $I$ after: $\tfrac12MR^2 + mR^2$.
Before (J)320$K_{child}$$K_{disk}$$\Delta E_{int}$After (J)91$K_{both}$229$\Delta E_{int}$
Energy bar charts for the child landing on the merry-go-round. Most of the kinetic energy becomes internal energy.
Pause and think
A child standing on the rim of a spinning merry-go-round walks toward the center. Does the merry-go-round speed up, slow down or keep the same angular velocity? (Frictionless axle.)
I thought about it. Show me
It speeds up. No external torque about the axle, so $L$ of the system is conserved. Moving her mass inward lowers the system's $I$, so $\omega$ rises: the stool problem again.
Check yourself
A 0.050 kg lump of clay moving at 6.0 m/s strikes and sticks to the end of a uniform 0.90 kg, 1.2 m rod that can spin about a frictionless pin through its center, perpendicular to the rod. The clay moves perpendicular to the rod. The rod's $I$ about its center is 0.108 kg·m². What is the angular velocity just after?
  1. A0.33 rad/s
  2. B1.4 rad/s
  3. C1.7 rad/s
  4. D2.8 rad/s
Show the answer

B. $L = mvr_\perp = (0.050)(6.0)(0.60) = 0.18$ kg·m²/s. After: $I = 0.108 + (0.050)(0.60)^2 = 0.126$ kg·m², so $\omega = 0.18/0.126 = 1.4$ rad/s. 1.7 rad/s forgets to add the clay's own rotational inertia. Linear momentum would be the wrong tool: the pin exerts an external force.

Exam tip from Mr. T

If an object is pinned, on an axle or hinged, linear momentum is not conserved in the collision. Say so, and switch to angular momentum about the pin. That one sentence is often a scoring point.

  • A pin or axle exerts an external force, so linear momentum isn't conserved, but that force has no torque about the pin, so angular momentum is.
  • A point mass's angular momentum before the collision is $mvr_\perp$; after sticking, add its $mr^2$ to the total $I$.
  • Sticking rotational collisions lose kinetic energy, just like perfectly inelastic linear ones.