AP Physics C: Mechanics · Unit 1 lecture · Part 3 of 10 · 10 min

1.2 Displacement, velocity and accelerationGoing back up the chain: integrals and starting values

Mr. Thompkins
Here's the direction you'll use the most. In Unit 2, forces will hand you the acceleration. You'll want the velocity and position. That means undoing the derivative, and undoing a derivative is integrating.

If $a = \frac{dv}{dt}$, then a small change in velocity is $dv = a\,dt$. Add up all those small changes from time 0 to time $t$ and you get the total change in velocity:

$$v(t) = v_0 + \int_0^t a\,dt \qquad x(t) = x_0 + \int_0^t v\,dt$$

The integral gives you only the change. The starting value, $v_0$ or $x_0$, is the piece of information that pins down the actual answer. Two cars with the same acceleration all morning can have very different speeds if one started at rest and the other started at 20 m/s. Forgetting the starting value is the single most common Unit 1 mistake on free-response questions.

?Wait, what's an antiderivative, and why is there a "+ C"?
An antiderivative undoes a derivative. By the reverse power rule, $\int t^n\,dt = \frac{t^{n+1}}{n+1} + C$ (for $n \ne -1$). The $+C$ is there because every constant has derivative zero, so the derivative alone can't tell you what constant you started with. In physics, $C$ is fixed by a starting condition like $v(0)$.
?Wait, why does an integral equal an area?
$\int_a^b f\,dt$ adds up thin strips of height $f$ and width $dt$, which is the area between the curve and the time axis. Area above the axis counts positive and area below counts negative. The fundamental theorem of calculus says this equals $F(b) - F(a)$ for any antiderivative $F$.
00.511.522.533.501234567t (s)a (m/s²)area = Δv = 9 m/s$a = 6 - 2t$
Area under a(t) is the change in velocity. Here a = 6 − 2t from 0 to 3 s: a triangle of area ½(3)(6) = 9 m/s.

Where the constant-acceleration equations come from

Integrate a constant acceleration $a$ and you get $v = v_0 + at$. Integrate that and you get $x = x_0 + v_0t + \frac12 at^2$. Eliminate $t$ between them and you get $v^2 = v_0^2 + 2a\Delta x$. So those Physics 1 equations aren't separate laws. They're what the definitions give you in the special case where $a$ is constant. If $a$ changes with time, they are simply wrong, and you have to go back to the integrals.

Pause and think
A student is told that $a(t) = 6t$ and uses $x = \frac12 at^2$ with $a = 6t$ plugged in, getting $x = 3t^3$. Starting from rest at the origin, what's the right answer?
I thought about it. Show me
Integrate twice: $v = \int_0^t 6t\,dt = 3t^2$, then $x = \int_0^t 3t^2\,dt = t^3$. The student's $3t^3$ is three times too big, because $\frac12 at^2$ is only true when $a$ is constant.
Up the chain, with distance
A cart moves along a track with $a(t) = 6 - 2t$ (SI units). At $t = 0$ it is at $x = 2.0\ \text{m}$ moving with $v = -5.0\ \text{m/s}$. (a) Find $v(t)$. (b) Find $x(t)$. (c) Find the cart's displacement and the total distance it travels from $t = 0$ to $t = 3.0\ \text{s}$.
00.511.522.53-6-5-4-3-2-1012345t (s)v (m/s)$-2.33$ m$+5.33$ m
Velocity of the cart. The red area (below the axis) is the backward leg, the blue area the forward leg.
  1. (a) $v(t) = v_0 + \int_0^t a\,dt = -5 + \int_0^t (6 - 2t)\,dt = -5 + 6t - t^2$.
    Why?
    Write the definition with the starting value first. Then the constant is built in and you can not lose it.
  2. (b) $x(t) = x_0 + \int_0^t v\,dt = 2 - 5t + 3t^2 - \frac{t^3}{3}$.
    Why?
    Integrate term by term: −5 becomes −5t, 6t becomes 3t², and −t² becomes −t³/3.
  3. (c) Check for turning points: $v = -(t^2 - 6t + 5) = -(t - 1)(t - 5) = 0$ at $t = 1\ \text{s}$ (and 5 s, outside the interval). So the cart reverses once, at 1 s.
    Why?
    Distance needs the turning points. Without this step you will report the displacement by mistake.
  4. Positions: $x(0) = 2.0$, $x(1) = 2 - 5 + 3 - \frac13 = -0.33\ \text{m}$, $x(3) = 2 - 15 + 27 - 9 = 5.0\ \text{m}$.
  5. Displacement: $x(3) - x(0) = 5.0 - 2.0 = +3.0\ \text{m}$. Distance: $|{-0.33} - 2.0| + |5.0 - (-0.33)| = 2.33 + 5.33 = 7.7\ \text{m}$.
    Why?
    The two legs match the signed areas under v(t): −2.33 m and +5.33 m. Add their sizes for distance, add them with signs for displacement.

Answer: (a) $v = -5 + 6t - t^2$ (b) $x = 2 - 5t + 3t^2 - t^3/3$ (c) Displacement +3.0 m, distance about 7.7 m.

Stuck? Get a hint
  1. Start from v = v₀ + ∫a dt with v₀ = −5.0 m/s.
  2. For distance, set v = 0. The cart turns around at t = 1 s.
  3. Find x at 0, 1 and 3 s, then add the sizes of the two legs.
Check yourself
An object has $a(t) = 4t$ (SI units) and $v(0) = 3.0\ \text{m/s}$. What is its velocity at $t = 3.0\ \text{s}$?
  1. A12 m/s
  2. B18 m/s
  3. C21 m/s
  4. D39 m/s
Show the answer

C. $v = 3 + \int_0^3 4t\,dt = 3 + 2t^2\big|_0^3 = 3 + 18 = 21\ \text{m/s}$. Choice B forgets the starting velocity. Choice D treats the acceleration as constant at its final value, $a(3) = 12$, times 3 s, plus 3.

Exam tip from Mr. T

On a "derive" or "calculate" part, write the integral with its limits and the starting value: $v(t) = v_0 + \int_0^t a\,dt$. Then integrate, then substitute. Graders look for that first line, and it protects you from the missing-constant trap.

  • $v(t) = v_0 + \int_0^t a\,dt$ and $x(t) = x_0 + \int_0^t v\,dt$.
  • Area under $a(t)$ is $\Delta v$. Area under $v(t)$ is $\Delta x$. Area below the axis is negative.
  • Starting values fix the constants. Never drop them.
  • Distance: find where v = 0, split the motion there, add the size of each leg.
  • Constant-acceleration equations are a special case. Use them only when a is truly constant.