AP Physics C: E&M · Unit 9 lecture · Part 5 of 10 · 10 min

9.2 Electric potential of charge distributionsPotential of rods, rings and disks

Mr. Thompkins
Remember the rod and the ring from Unit 8, where you had to break every piece's field into components? Same objects, but now the integral is friendlier. Potential is a scalar, so nothing cancels and nothing needs a cosine.

Chop the distribution into pieces dq. Each contributes $dV = \frac{k\,dq}{r}$, where r is that piece's distance from P. Add them all:

$$V = \int\frac{k\,dq}{r}$$

Because nothing points anywhere, you never have to cancel components. You just need dq in terms of a variable and the distance r in terms of that same variable.

P$dq$$x$$d$$dV = \frac{k\,dq}{x}$rod: distance changesCarc: every piece is R away$V = kQ/R$
Left: on a rod, each piece is a different distance x from P, so x goes inside the integral. Right: on an arc, every piece is the same distance R from the center.

A rod, on its axis

Put P at the origin and a rod of uniform density λ from $x = d$ to $x = d + L$. A piece at x is a distance x away:

$$V = \int_d^{d+L}\frac{k\lambda\,dx}{x} = k\lambda\ln\frac{d+L}{d}$$

?Wait, why does $\int dx/x$ give a logarithm?
$\frac{d}{dx}\ln x = \frac{1}{x}$, so $\int_a^b\frac{dx}{x} = \ln b - \ln a = \ln\frac{b}{a}$. Whenever a potential integral has a $1/x$ with nothing else, a log appears.
Potential of a rod
A rod of length 0.20 m holds 4.0 nC spread uniformly. Find the potential on its axis 0.10 m beyond one end.
  1. $\lambda = \frac{4.0 \times 10^{-9}}{0.20} = 2.0 \times 10^{-8}$ C/m.
  2. $V = k\lambda\ln\frac{d+L}{d} = (9.0 \times 10^9)(2.0 \times 10^{-8})\ln\frac{0.30}{0.10} = 180\ln 3 = 198$ V.
  3. Sanity check: a point charge of 4.0 nC at the rod's center, 0.20 m away, would give $kQ/0.20 = 180$ V. That estimate is a little low, which makes sense: the 1/x weights the near end, which is closer than 0.20 m, more heavily than the far end.

Answer: About 198 V, or $2.0 \times 10^2$ V.

Stuck? Get a hint
  1. λ = Q/L.
  2. dV = kλ dx / x, integrated from d to d + L.
  3. ∫dx/x from 0.10 to 0.30 is ln 3.

Arcs and rings

On an arc or ring, every piece is the same distance from the center, so $V = \frac{k}{R}\int dq = \frac{kQ}{R}$ at the center, whatever fraction of a circle it is. For a ring of radius a, on its axis a distance z from the center, every piece is $\sqrt{z^2 + a^2}$ away:

$$V_{\text{ring}}(z) = \frac{kQ}{\sqrt{z^2 + a^2}}$$

Pause and think
The field at the center of a ring is zero, but the potential is $kQ/a$, not zero. How can both be true?
I thought about it. Show me
Field is a vector, and the pieces on opposite sides push in opposite directions, so they cancel. Potential is a scalar: every piece adds a positive $k\,dq/a$, and nothing cancels. The field is related to how V changes (its slope), and at the center V is at a maximum along the axis, so its slope is zero.
00.10.20.30.40100200300400500$z$ (m)$V$ (V)flat top: E = 0steepest: E largest318 V
Potential on the axis of a ring (Q = 5.0 nC, a = 0.10 m). It is largest at the center, where the curve is flat, and its slope is steepest at z = a/√2, where the field is largest.
From V to E for the ring
Use $V(z) = \frac{kQ}{\sqrt{z^2 + a^2}}$ to find the field on the axis of a ring.
  1. On the axis, by symmetry, $\vec E$ points along z, and $E_z = -\frac{dV}{dz}$.
    Why?
    The next sections develop this rule. It works here because the symmetry tells us there is only a z component on the axis.
  2. $\frac{dV}{dz} = kQ\cdot\left(-\tfrac{1}{2}\right)(z^2 + a^2)^{-3/2}(2z) = -\frac{kQz}{(z^2 + a^2)^{3/2}}$.
    Why?
    Chain rule: the outside power drops by one, times the derivative of the inside, 2z.
  3. $E_z = \frac{kQz}{(z^2 + a^2)^{3/2}}$, the same result Unit 8 needed components and cancellation to get.

Answer: $E_z = \frac{kQz}{(z^2 + a^2)^{3/2}}$. Finding V first and differentiating is often the easier road.

Stuck? Get a hint
  1. Write V as kQ(z² + a²)^(−1/2).
  2. Differentiate with the chain rule.
  3. Then put a minus sign in front: E = −dV/dz.

A disk, built from rings

A uniformly charged disk of radius R and surface density σ is a stack of thin rings. A ring of radius r' and width dr' has area $2\pi r'\,dr'$, so $dq = \sigma 2\pi r'\,dr'$. On the axis:

$$V = \int_0^R\frac{k\sigma 2\pi r'\,dr'}{\sqrt{z^2 + r'^2}} = 2\pi k\sigma\left(\sqrt{z^2 + R^2} - z\right)$$

?Wait, why is a thin ring's area 2πr dr?
Cut the ring and straighten it: it's a thin strip with length equal to the circumference $2\pi r$ and width $dr$. Length times width is $2\pi r\,dr$.
Potential of a disk
A flat plastic disk of radius 0.10 m holds 2.0 nC spread uniformly over one face. Find the potential on its axis (a) at the center and (b) 0.10 m from the center.
  1. $\sigma = \frac{2.0 \times 10^{-9}}{\pi(0.10)^2} = 6.37 \times 10^{-8}\ \text{C/m}^2$, and $2\pi k\sigma = 2\pi(9.0 \times 10^9)(6.37 \times 10^{-8}) = 3600$ V/m.
  2. (a) At z = 0: $V = 3600(\sqrt{0 + 0.010} - 0) = 3600(0.10) = 360$ V.
  3. (b) At z = 0.10 m: $V = 3600(\sqrt{0.020} - 0.10) = 3600(0.0414) = 149$ V.

Answer: (a) 360 V. (b) About 150 V.

Check yourself
A thin rod bent into a quarter circle of radius R carries charge Q. What is the potential at the center of the circle?
  1. A$kQ/R$
  2. B$kQ/(4R)$
  3. C$4kQ/R$
  4. D$\sqrt2\,kQ/(2R)$
Show the answer

A. Every piece is R from the center, and potential is a scalar, so $V = kQ/R$ for any arc. The $\sqrt2$ choice comes from treating V like a vector with components.

Exam tip from Mr. T

If an FRQ asks for both E and V of a distribution, find V first when you can (no components), then get E from $E = -dV/dz$ along a symmetry axis. Say why only one component survives.

  • $V = \int k\,dq/r$: a scalar integral, no components.
  • Rod on its axis: $V = k\lambda\ln[(d+L)/d]$.
  • Any arc or ring at its center: $V = kQ/R$. Ring on its axis: $kQ/\sqrt{z^2+a^2}$.
  • Disk on its axis: $V = 2\pi k\sigma(\sqrt{z^2+R^2} - z)$, built from rings with $dq = \sigma 2\pi r\,dr$.