AP Physics 1 · Unit 7 lecture · Part 8 of 11 · 9 min

7.4 Energy of simple harmonic oscillatorsEnergy sloshing back and forth

Mr. Thompkins
Here's the friendliest idea in the unit. Forget timing for a minute. If there's no friction, the total energy never changes, it just moves back and forth between two bins. That one sentence answers every "how fast is it going here" question.
?Wait, what's the energy stored in a spring?
From Unit 3: a spring stretched or compressed by $x$ stores elastic potential energy $U_s = \tfrac12 kx^2$. It's never negative, and it depends on $x^2$, so stretching by $x$ or squeezing by $x$ stores the same energy. Doubling $x$ stores four times as much.

Take the block-spring system on a frictionless surface. The spring does work on the block, but the spring is inside the system, so no external force does work and the total mechanical energy stays constant: $E = K + U_s = \tfrac12 mv^2 + \tfrac12 kx^2$.

At an end, $x = \pm A$ and $v = 0$, so all the energy is spring energy: $E = \tfrac12 kA^2$. At equilibrium, $x = 0$, so all the energy is kinetic: $E = \tfrac12 mv_{max}^2$. Everywhere in between it's a mix, and the two parts always add to the same total. This gives you the total energy from just two numbers, $k$ and $A$, and it shows why amplitude matters so much: double the amplitude and the energy goes up by four.

?Wait, what's a system, and when is its energy conserved?
A system is whatever objects you choose to analyze together. Its total energy changes only if something outside the system does work on it (or heat flows in or out). Choose block plus spring, ignore friction, and nothing outside does work, so the system's mechanical energy stays constant.
At x = A0.60$U_s$$K$0.60$E$At x = A/20.15$U_s$0.45$K$0.60$E$At x = 0$U_s$0.60$K$0.60$E$
Energy bar charts for k = 120 N/m and A = 0.10 m (in joules). The total stays 0.60 J. Halfway out, the spring holds only a quarter of it, because U depends on x².

Look at the middle chart. Halfway to the end, $x = \frac{A}{2}$, the spring energy is $\tfrac12 k\left(\frac{A}{2}\right)^2 = \frac14 \cdot \tfrac12 kA^2$, only one quarter of the total. The other three quarters are kinetic. Halfway in position is nowhere near halfway in energy. That's the single most common slip in this topic.

-0.1-0.0500.050.100.10.20.30.40.50.60.7x (m)energy (J)E = 0.60 J$U_s = \tfrac12 kx^2$$K$
Energy against position. The spring energy is a parabola, kinetic energy is the total minus that, and the total is a flat line. The block can only be where K is zero or positive: between −A and +A.

The energy graph also shows why the block turns around at $\pm A$. Past those points the spring energy would be bigger than the total, so the kinetic energy would have to be negative, which is impossible. The amplitude is set by how much energy you put in.

Pause and think
At $x = \frac{A}{2}$, what fraction of the oscillator's energy is kinetic? Is its speed half of $v_{max}$, more, or less?
I thought about it. Show me
Three quarters of the energy is kinetic. Speed goes like the square root of kinetic energy, so $v = \sqrt{\tfrac34}\,v_{max} \approx 0.87\,v_{max}$: much more than half. The block is still moving fast when it's halfway out.
Speed from energy
A 0.30 kg block on a frictionless table is attached to a spring with $k = 120\ \text{N/m}$ and oscillates with amplitude 0.10 m. (a) Find the total energy. (b) Find the maximum speed. (c) Find the speed at $x = 0.050\ \text{m}$. (d) At what position are the kinetic and potential energies equal?
At x = A0.60$U_s$$K$0.60$E$At x = A/20.15$U_s$0.45$K$0.60$E$At x = 0$U_s$0.60$K$0.60$E$
The bar charts for this oscillator.
  1. (a) At the end, all of the energy is in the spring: $E = \tfrac12 kA^2 = \tfrac12(120)(0.10)^2 = 0.60\ \text{J}$.
    Why?
    Start from the principle in words or symbols: the system has no external work, so E is constant and equals the value at the end.
  2. (b) At equilibrium, all of it is kinetic: $\tfrac12 mv_{max}^2 = 0.60$, so $v_{max} = \sqrt{\frac{2(0.60)}{0.30}} = 2.0\ \text{m/s}$.
  3. (c) At 0.050 m: $U_s = \tfrac12(120)(0.050)^2 = 0.15\ \text{J}$, so $K = 0.60 - 0.15 = 0.45\ \text{J}$ and $v = \sqrt{\frac{2(0.45)}{0.30}} = 1.7\ \text{m/s}$.
    Why?
    Write the conservation equation, then solve: E = K + U at that point.
  4. (d) $K = U_s$ means each is half the total: $\tfrac12 kx^2 = \tfrac12\left(\tfrac12 kA^2\right)$, so $x^2 = \frac{A^2}{2}$ and $x = \frac{A}{\sqrt2} = 0.071\ \text{m}$ (on either side).

Answer: (a) 0.60 J. (b) 2.0 m/s. (c) 1.7 m/s. (d) At $x = \pm 0.071\ \text{m}$, not at A/2.

Stuck? Get a hint
  1. Find the total from the end: $E = \tfrac12 kA^2$.
  2. At any position, $K = E - \tfrac12 kx^2$.
  3. Then $v = \sqrt{2K/m}$.
Check yourself
A block on a spring oscillates with amplitude A. The block is replaced by one with four times the mass, released from the same amplitude. Which is true?
  1. AThe total energy and the maximum speed both stay the same.
  2. BThe total energy stays the same, the maximum speed is halved, and the period doubles.
  3. CThe total energy quadruples and the period doubles.
  4. DThe total energy is quartered and the maximum speed stays the same.
Show the answer

B. $E = \tfrac12 kA^2$ has no mass in it, so the energy is unchanged. That same energy in four times the mass means $\tfrac12 mv_{max}^2$ is fixed, so $v_{max}$ halves. And $T \propto \sqrt{m}$ doubles. Choosing "energy quadruples" mixes up mass with amplitude.

Exam tip from Mr. T

On a speed question, write the energy equation before you touch numbers: $\tfrac12 kA^2 = \tfrac12 mv^2 + \tfrac12 kx^2$. The equation itself is usually worth a point, and it stops you from using kinematics equations, which do not work here because the acceleration keeps changing.

  • $E = K + U_s = \tfrac12 mv^2 + \tfrac12 kx^2 = \tfrac12 kA^2$, constant without friction.
  • All potential at the ends, all kinetic at equilibrium.
  • At $x = A/2$: one quarter potential, three quarters kinetic. K = U at $x = A/\sqrt2$.
  • Double the amplitude: four times the energy, twice the top speed, same period.
  • Constant-acceleration equations do not apply to SHM: use energy or the SHM equations.