7.1 Defining simple harmonic motionPulled back toward the middle

Start with a block on a frictionless table, attached to a spring whose other end is fixed to a wall. If you leave it alone, it sits at one spot where the spring is neither stretched nor squeezed. That spot is the equilibrium position: the place where the net force on the block is zero. We measure everything in this unit from there, and we call the block's position $x$, its displacement from equilibrium.
?Wait, what's Hooke's law again?
Now pull the block to the right and let go. The spring pulls it back to the left. As it moves left it speeds up, and when it reaches equilibrium the force drops to zero, but the block is moving fast, so it keeps going. Inertia carries it past the middle. Now the spring is compressed and pushes right, slowing it down until it stops on the far side. Then the whole thing runs in reverse. The block overshoots, comes back, overshoots again, and repeats. That back and forth is an oscillation.
The force that makes this happen has a name: a restoring force, because it always points back toward equilibrium. For the spring, the restoring force is $F = -kx$. Read that minus sign as a sentence: "the force points the opposite way from the displacement." Block to the right ($x$ positive), force to the left. Block to the left ($x$ negative), force to the right. And the size of the force is proportional to how far away the block is: twice as far, twice the pull.
Here is the definition the whole unit rests on. Simple harmonic motion (SHM) is the motion of an object acted on by a restoring force that is proportional to its displacement from equilibrium and directed toward equilibrium. In symbols, $F_{net} = -kx$, where $k$ is some positive constant. Any system with that force law, whatever it looks like, moves the same way: same graphs, same equations, same energy story.
?Wait, how does a force tell me the acceleration?
There is a clean test you can apply to any graph of net force against displacement. If the motion is SHM, the graph is a straight line through the origin with a negative slope, and that slope is $-k$. A straight line means "proportional". Through the origin means "zero force at equilibrium". Negative slope means "restoring".
Repeating is not enough
Lots of motions repeat without being simple harmonic. A ball bouncing on a hard floor repeats, but while it's in the air the only force is gravity, which is the same size no matter how high the ball is. A ball rolling back and forth in a V-shaped trough repeats too, but on each straight side the force along the slope is constant: it flips direction at the bottom without growing with distance. Neither force is proportional to the displacement, so neither motion is SHM, and the formulas of this unit won't predict their timing.
I thought about it. Show me
- (a) Start from the restoring force law: $F = -kx = -(40\ \text{N/m})(0.15\ \text{m}) = -6.0\ \text{N}$.
Why?
On the table the normal force and gravity cancel, so the spring force is the net force. Writing the law before the numbers is what the "starting point" point on an FRQ is for. - $a = \frac{F}{m} = \frac{-6.0\ \text{N}}{0.80\ \text{kg}} = -7.5\ \text{m/s}^2$: 7.5 m/s² toward equilibrium (to the left).
Why?
Give a direction with the magnitude. "7.5 m/s²" alone leaves out half the answer. - (b) $F = -(40)(-0.05) = +2.0\ \text{N}$ and $a = \frac{2.0}{0.80} = +2.5\ \text{m/s}^2$, both to the right, toward equilibrium.
Why?
The block is left of equilibrium, so the restoring force points right. The signs take care of that for you. - (c) Since $a = -\frac{k}{m}x$, the acceleration is zero at $x = 0$ and largest in size where $|x|$ is largest: at the ends, $x = \pm 0.15\ \text{m}$, where it is 7.5 m/s².
Answer: (a) 6.0 N and 7.5 m/s², both toward equilibrium (negative). (b) 2.0 N and 2.5 m/s², both positive. (c) Zero at equilibrium, largest (7.5 m/s²) at the two ends.
Stuck? Get a hint
- Write $F = -kx$ and put in the position with its sign.
- Then divide by the mass to get the acceleration.
- A negative answer means "to the left", which is back toward the middle when the block is on the right.
- A$F = -5x$
- B$F = -5$ whenever $x > 0$ and $+5$ whenever $x < 0$
- C$F = -5x^2$
- D$F = +5x$
Show the answer
A. Only $F = -5x$ is proportional to $x$ and always points back toward equilibrium. The second choice is the V-trough: a constant-size restoring force, so periodic but not SHM. $+5x$ pushes the object away from equilibrium, so it would run off instead of oscillating, and $-5x^2$ isn't proportional to $x$ (and points the wrong way when $x$ is negative).
- Equilibrium: where the net force is zero. Displacement x is measured from there.
- SHM: a restoring force proportional to the displacement and pointing toward equilibrium, $F = -kx$.
- So $a = -\frac{k}{m}x$: zero at equilibrium, largest at the ends, always pointing toward the middle.
- Test: net force against displacement is a straight line through the origin with negative slope.
- Repeating motion is not automatically SHM: a bouncing ball and a V-trough are periodic but not simple harmonic.