6.5 Rolling with slippingThe skidding bowling ball

When an object slips, $v_{cm} \neq R\omega$, and the contact point slides along the ground. Then the friction is kinetic, and it does do work: it turns kinetic energy into internal energy (the lane and ball warm up). Mechanical energy is not conserved during slipping.
?Wait, what's kinetic friction?
Follow the friction force. It points backward, opposite the slide, so it acts against the ball's forward motion: $v_{cm}$ decreases. But it acts at the bottom of the ball, below the center, so it also makes a torque, and that torque spins the ball forward: $\omega$ increases. The forward speed falls and the spin rises until they match, $v_{cm} = R\omega$. From then on the ball rolls without slipping, the contact point stops sliding, and kinetic friction stops acting.
Beyond the course, as a bonus, here are the numbers behind that graph. A solid sphere launched at 8.0 m/s with no spin, $\mu_k = 0.20$, starts rolling after 1.17 s at $\tfrac57(8.0) = 5.7$ m/s, having lost $\tfrac27$ of its kinetic energy to internal energy. The AP exam asks you to reason about the directions and the energy, not to compute the timing.
I thought about it. Show me
- (a) The bottom of the ball slides forward along the lane, so kinetic friction on the ball points backward. It acts at the contact point, at the bottom.
Why?
Friction always opposes the sliding of the surfaces, which here is the bottom of the ball moving forward. - (b) Friction is the only horizontal force, and it points backward, so $a_{cm}$ is backward and $v_{cm}$ decreases. About the center, the backward force at the bottom makes a torque that turns the ball forward (the way it rolls), so $\omega$ increases.
Why?
One force, two effects: it slows the translation and speeds up the rotation. Use both laws: ΣF = Ma and Στ = Iα. - (c) While slipping, the contact point slides against kinetic friction, which turns kinetic energy into internal energy. Once $v_{cm} = R\omega$, the contact point is at rest, friction no longer acts as kinetic friction (and on level ground none is needed), so no energy is lost and the ball keeps rolling.
Why?
Point to the sliding contact as the reason. "There is friction" alone isn't enough: rolling objects have friction too.
Answer: (a) Backward, at the contact point. (b) The backward force slows $v_{cm}$, and its torque about the center increases ω. (c) Sliding contact turns kinetic energy into internal energy; when rolling begins, the sliding stops.
Stuck? Get a hint
- Which way does the bottom of the ball slide relative to the lane?
- Friction acts below the center: what torque does it make about the center?
- Energy is lost only where surfaces slide past each other.
- AIt stays in place and keeps spinning at the same rate.
- BKinetic friction pushes it forward, so it speeds up forward while its spin slows down.
- CKinetic friction pushes it backward and speeds up its spin.
- DIt rolls without slipping immediately.
Show the answer
B. The bottom of the wheel slides backward on the floor, so kinetic friction on the wheel points forward: it accelerates the center forward and its torque opposes the spin. $v$ rises and $\omega$ falls until $v = R\omega$. It's the bowling ball run in reverse.
- Slipping: $v_{cm}$ ≠ Rω, the contact point slides, and kinetic friction does work.
- Kinetic friction changes both motions at once: it changes $v_{cm}$ (force) and ω (torque about the center).
- The skid ends when $v_{cm}$ = Rω. Then the object rolls without slipping.
- Mechanical energy is lost while slipping, not while rolling.