AP Physics 1 · Unit 4 lecture · Part 11 of 11 · 8 min
Unit 4 wrap-upPut it together
Mr. Thompkins
That's the whole unit. Let's zoom out. Everything you did rests on one chain of reasoning: Newton's third law makes internal impulses cancel, so a system with no net external force keeps its total momentum. The rest is bookkeeping.
Idea
Equation
Use it when
Momentum
p = mv (a vector)
Any moving object; add with signs for a system
Impulse
J = F·Δt = Δp
A force acts for a time; area under F-t
Conservation
total p before = total p after
No net external force on the system
Center of mass
$v_{cm}$ = total p / total m
Tracking a whole system through a collision
Kinetic energy
K = ½mv²
Deciding elastic or inelastic; explosions
Unit 4 on one page.
Here's how the topics connect. Momentum (4.1) is what gets traded. Impulse (4.2) is how it's traded: a force acting for a time. When the trading happens inside a system, the total can't change (4.3), and the center of mass sails on at $p_{sys}/M$. Then kinetic energy sorts the trades into elastic, inelastic and perfectly inelastic (4.4), and explosions run the movie backward, with stored energy turning into kinetic energy.
?Wait, when is momentum not conserved?
Whenever there's a net external impulse on the system you chose: a wall, a hand, a pin, friction acting over a long time, or gravity on a falling object if the Earth isn't in your system. Fix it by choosing a bigger system, or by keeping your "before" and "after" close to the collision.
Pause and think
Connect two ideas: in a perfectly inelastic collision, why does the center of mass help you find the final velocity instantly?
I thought about it. Show me
The objects stick, so afterward they all move with the center of mass. And with no net external force, $v_{cm}$ doesn't change. So the final velocity is just $v_{cm} = p_{sys}/M$, computed from the "before" numbers.
?Wait, what's the difference between elastic and inelastic again?
Both conserve the momentum of an isolated system. Elastic also keeps the total kinetic energy the same. Inelastic turns some kinetic energy into internal energy and sound. Perfectly inelastic means the objects stick, which loses the most kinetic energy possible.
Traps that cost points
✕ Writing a bounce as Δp = m(v − v) = 0 because the speed is the same.
✓ The direction flips, so $v_f$ has the opposite sign. Δp = −2mv for a reversal at the same speed.
✕ Assuming kinetic energy is conserved because momentum is.
✓ Momentum is conserved in every isolated collision. Kinetic energy only in elastic ones. Check with numbers.
✕ Dropping the minus sign for an object moving left.
✓ Pick a positive direction at the start and give every velocity its sign.
✕ Using momentum conservation when an outside force acts: a wall, a pin, long-lasting friction.
✓ Name the system and check the external forces before you write the equation.
✕ Giving kinetic energy a sign, or letting energies cancel.
✓ Kinetic energy is a scalar and never negative.
✕ Reporting the peak of a triangular force-time graph as the average force.
✓ Average force = impulse / time. For a symmetric triangle it is half the peak.
✕ Using energy conservation straight through a sticky collision.
✓ Momentum for the collision stage, energy for the stages before and after.
✕ Forgetting the initial momentum when an impulse acts on a moving object.
✓ Final momentum = initial momentum + impulse.
Key relationships for Unit 4
$\vec p = m\vec v$
MomentumA vector along the velocity
$\vec J = \vec F_{avg}\Delta t = \Delta\vec p$
Impulse-momentum theoremAlso the area under a force-time graph
$\Sigma\vec F = \frac{\Delta\vec p}{\Delta t}$
Second law, momentum formSlope of a momentum-time graph
$\Sigma p_{before} = \Sigma p_{after}$
Conservation of momentumNo net external force on the system
Velocity of the center of massConstant for an isolated system
$K = \tfrac12mv^2 = \frac{p^2}{2m}$
Kinetic energyElastic or inelastic? Explosions
$v' = \frac{m_Av_A + m_Bv_B}{m_A + m_B}$
Perfectly inelasticObjects that stick together
FRQ strategy for Unit 4
Name the system and the positive direction in your first line.
Justify every conservation statement: "the net external force on the system is zero (or negligible during the collision), so the system's momentum is conserved."
Mathematical Routines: start from a principle in symbols, solve in symbols when asked to derive, then substitute with units.
Translation Between Representations: make your bar chart, graph and equation agree. On force-time graphs, area is impulse; the third-law partner is the mirror image below the axis.
Qualitative/Quantitative Translation: claim first, then the principle, then what changes and what stays the same ("same Δp, longer Δt, smaller force").
Experimental Design: linearize, read the slope from the best-fit line, name your measuring tools, and repeat trials.
In two-stage problems, label the stages and the law for each.
Mixed FRQ practice
Block A (2.0 kg) slides right at 6.0 m/s on a frictionless surface toward block B (4.0 kg), which is at rest with a light spring attached to its left side. A compresses the spring, and at the moment of maximum compression both blocks move with the same velocity. (a) Find that common velocity. (b) Find the energy stored in the spring at maximum compression. (c) After the spring pushes them apart, the collision turns out to be elastic. Find both final velocities.
(a) System: A + B + spring. No net external horizontal force, so momentum is conserved. At maximum compression they share one velocity: $(2.0)(6.0) = (6.0)v$, so $v = 2.0$ m/s, right.
Why?
At maximum compression the blocks are momentarily moving together, exactly like a sticking collision, for one instant.
(b) Kinetic energy before: $\tfrac12(2.0)(6.0)^2 = 36$ J. At maximum compression: $\tfrac12(6.0)(2.0)^2 = 12$ J. The spring stores the difference, $36 - 12 = 24$ J.
Why?
With a spring and no friction, the "missing" kinetic energy is stored, not turned into internal energy.
(c) Elastic, so both momentum and kinetic energy are conserved. Use the equal-approach-and-separation speeds, or the formulas: $v_A' = \dfrac{m_A - m_B}{m_A + m_B}v_A = \dfrac{-2.0}{6.0}(6.0) = -2.0$ m/s and $v_B' = \dfrac{2m_A}{m_A + m_B}v_A = \dfrac{4.0}{6.0}(6.0) = 4.0$ m/s.
Why?
Check momentum: (2.0)(−2.0) + (4.0)(4.0) = 12 ✓. Check energy: 4.0 + 32 = 36 J ✓. Always verify when you use a shortcut.
Answer: (a) 2.0 m/s right. (b) 24 J. (c) A: 2.0 m/s left; B: 4.0 m/s right.
Stuck? Get a hint
At maximum compression, the two blocks have the same velocity, so treat that instant like a sticking collision.
The spring energy is the kinetic energy that went missing.
For the elastic result, check both momentum (12 kg·m/s) and kinetic energy (36 J).
Check yourself
A 0.20 kg ball moving at 5.0 m/s strikes a wall and bounces back at 3.0 m/s. A second, identical ball strikes the wall at 5.0 m/s and sticks. Which ball receives the larger impulse, and by how much?
AThe sticking ball, by 0.60 N·s
BThe bouncing ball, by 0.60 N·s
CThe bouncing ball, by 1.6 N·s
DThey receive the same impulse
Show the answer
B. Bouncing: $|\Delta p| = (0.20)(5.0 + 3.0) = 1.6$ N·s. Sticking: $(0.20)(5.0) = 1.0$ N·s. The bouncing ball receives 0.60 N·s more. 1.6 N·s is the bouncing ball's whole impulse, not the difference.
Check yourself
Two pucks collide on frictionless ice. Which quantity must be the same just before and just after the collision?
AThe speed of each puck
BThe kinetic energy of the two-puck system
CThe momentum of each puck
DThe velocity of the center of mass of the two pucks
Show the answer
D. The system is isolated, so its total momentum, and therefore $v_{cm} = p_{sys}/M$, can't change. Individual momenta and speeds change in a collision, and the system's kinetic energy is conserved only if the collision is elastic.
Mr. Thompkins
That's Unit 4. Go take the Unit 4 quiz while it's fresh, and when you miss one, come back to that section and open its "Wait, what's that again?" cards. Next up, Unit 5: we take everything you know about forces and make it spin.