AP Biology · Unit 4 lecture · Part 9 of 11 · 7 min

4.6 Regulation of the cell cycle: checkpoints, cyclins and CDKsCheckpoints: stop or go

Mrs. Otero
Dividing a cell with damaged DNA would copy the damage into every descendant. So cells don't just divide on a timer. They stop at checkpoints and ask: is it safe to go on?

A number of internal controls, called checkpoints, regulate progress through the cell cycle. At the G₁ checkpoint, the cell checks its size, its nutrients, whether growth signals are present, and whether its DNA is damaged, before committing to copy its DNA. At the G₂ checkpoint, it checks that DNA replication is complete and damage has been repaired before mitosis. At the M checkpoint (the spindle checkpoint), it checks that every chromosome is attached to the spindle before the sister chromatids separate. If a check fails, the cycle pauses for repair, the cell may enter G₀, or it is sent into apoptosis.

CheckpointWhenWhat it checksIf the check fails
G₁Before DNA replicationCell size, nutrients, growth signals, DNA damagePause, enter G₀, or apoptosis
G₂Before mitosisDNA fully copied, damage repairedPause for repair, or apoptosis
M (spindle)Before anaphaseEvery chromosome attached to the spindleSister chromatids don't separate yet
The three checkpoints and what each one checks.
?Wait, what's a kinase again?
A kinase is an enzyme that attaches a phosphate group (from ATP) to another protein, often switching it on or off. You met kinases in signaling cascades earlier in this unit.

Checkpoints work through the interaction of two kinds of proteins. Cyclin-dependent kinases (CDKs) are kinases that are only active when bound to a cyclin. CDK levels stay fairly steady through the cycle. Cyclin levels rise and fall: cyclin is made and accumulates during interphase, binds CDK, and when enough active cyclin-CDK complex builds up, it phosphorylates target proteins that push the cell past a checkpoint. Then the cyclin is broken down, the CDK goes inactive, and the cycle resets. You don't need to know which cyclin pairs with which CDK.

04812162024020406080100time (h)relative levelCDK amount (steady)cyclincyclin-CDK activitymitosis
Schematic levels through one cycle. CDK stays steady; cyclin builds up through interphase; cyclin-CDK activity spikes once cyclin passes a threshold and drives the cell into mitosis; then cyclin is destroyed and activity drops.
?Wait, how is this like the signaling pathways earlier?
It's the same toolkit: proteins switched on by binding a partner (CDK by cyclin) and by phosphorylation. Growth-factor pathways from Topic 4.3 often work by raising cyclin levels, which is how an outside signal tells a cell to pass the G₁ checkpoint.
Pause and think
On the graph, cyclin rises steadily from 0 h, but cyclin-CDK activity stays near zero until about 14 h. Why the delay?
I thought about it. Show me
Activity depends on enough cyclin binding CDK to cross a threshold. Early on there isn't enough cyclin to activate much CDK; once cyclin builds up past the threshold, activity rises steeply and peaks just before mitosis.
Explain the timing and predict
Use the cyclin graph. (a) Explain why cyclin-CDK activity peaks at 20 h and falls right after. (b) Predict what would happen to a cell whose cyclin could not be broken down, and justify. (c) Predict what would happen if a cell could not make cyclin.
  1. (a) Cyclin has accumulated to its highest level by 20 h, so the most CDK is active and the cell is driven into mitosis. Then cyclin is broken down, so CDK loses its partner and activity drops.
    Why?
    Activity tracks cyclin, because CDK is active only when bound to cyclin.
  2. (b) With cyclin never destroyed, CDK activity stays high, and the cell can't reset to finish mitosis and start a new cycle normally. It would be stuck.
    Why?
    The fall in cyclin is part of the control; a switch that can't turn off is as harmful as one that can't turn on.
  3. (c) Without cyclin, CDK is never activated, so the cell can't pass the checkpoint and stays in interphase (or G₀).
    Why?
    Stuck off, the same logic as a broken signaling pathway.

Answer: (a) Activity follows cyclin: high cyclin activates CDK and triggers mitosis; destroying cyclin ends it. (b) The cell gets stuck with high CDK activity. (c) The cell can't pass the checkpoint.

Stuck? Get a hint
  1. What does CDK need in order to be active?
  2. When is cyclin highest, and what happens to it right after?
  3. No partner, no activity; a partner that never leaves, activity that never stops.
Check yourself
A cyclin-dependent kinase (CDK) is active only when
  1. Aits level rises during S phase
  2. Bit is bound to a cyclin
  3. Cthe cell is in G₀
  4. Dit is broken down after mitosis
Show the answer

B. CDKs need a cyclin partner to work. CDK levels stay fairly constant; it's cyclin that rises and falls and is destroyed after mitosis.

  • Checkpoints at G₁, G₂ and M check conditions such as DNA damage, complete replication and spindle attachment.
  • CDKs are kinases active only when bound to cyclins; CDK levels are steady while cyclin levels rise and fall.
  • Enough active cyclin-CDK pushes the cell past a checkpoint; destroying cyclin resets the cycle.
  • You don't need specific cyclin-CDK pairs or growth factor names.